Windows and doors in the home should be opened to help ventilate as these oils burn off. NOTE: If the unit does not start, DO NOT try to restart the unit until it has cooled completely down. If the unit does not start or maintain a fire, you will receive an E-2 in the Heat Range and Blower Speed window of the Control Board. If this occurs, wait until unit has cooled completely down and repeat these steps. FUEL NOT FEEDING CORRECTLY If the fuel is not feeding correctly, the feed auger could possi

(51 mm) c Nonsoluble factory, chimney longlh ceman: Chimney length flush with inside of flue N Air speco 9 in. (229 mm) min. X . s « Minimum clearance 9 in* (229 mm) Chimney connector Masonry chimney constructed ' ' NFPA211 ___ii Use chimney it\(mfrs, parts lo attach connector securely Solid-insulated, listed faclory-buiSt chimney length Solid-insulated, listed factoiy-built chimney length of the same inside diameter as the chimney connector and having 1-in. or more of

CONTACT CUSTOMER SERVICE @ 1-800-245-6489. Questions? Need Parts or Options? Please Note the Following Precautionary Statements: England’s Stove Works highly recommends the use of smoke detectors and Carbon Monoxide detectors with any hearth product, including this unit. Follow all manufacturer’s instructions when using smoke or Carbon Monoxide detectors. CAUTION: This unit must be installed in accordance with these instructions and must comply with local building and fire codes. Failure to

Resizing with a stainless steel liner may be required. 11. It is recommended that no more than two 90-degree bends be used in the stovepipe installation. More than two 90-degree bends may decrease the amount of draw, and possibly cause smoke spillage. 12. A damper is not required in this installation. Remove the damper plate in the chimney or secure it in the OPEN position. 13. Single wall flue pipe assemblies must not exceed 10 feet in overall length. CHIMNEY REFER TO CHIMNEY AND CHIMNEY C

NOTE: It is important to heat the air in the stovepipe for draft to begin. ■ Fully open the air control of the wood stove, and close the door until it is just slightly open, allowing for air to be introduced into the firebox. Never leave the door fully open, as sparks from the kindling may occur, causing injury. As the fire begins to burn the kindling, some additional kindling may be needed to sustain the fire. DO NOT add more paper after the fire has started. ■ Once the kindling has begun to

If the J-Channel is too loose and will not stay in place, lay the piece on a flat surface and bend the short side in on each end and slightly in the middle. Follow this procedure with each piece. AC-106-P & SH-106-P Brass Window Trim With the door closed, take the spring clip that has a tee on one end and twist it into the groove on the rear side of the window trim. You can place the spring clip on any side of the trim; however, the side of the trim toward the bottom of the door is best. Hold th

Visit our web site at for helpful information, frequently asked questions, parts & accessory orders and more. NOTE: IF YOU HAVE A PROBLEM WITH THIS UNIT DO NOT RETURN IT TO THE DEALER. CONTACT CUSTOMER SERVICE @ 1-800-245-6489. Please note the following Precautionary Statements: CAUTION: This unit must be installed in accordance with these instructions and must comply with local building and fire codes. Failure to do so could result in a chimney or house fire, property damage, bodily injury or e

Visit our web page at for helpful information, frequently asked questions, parts & accessory orders and more. NOTE: IF YOU HAVE A PROBLEM WITH THIS UNIT DO NOT RETURN IT TO THE DEALER. CONTACT CUSTOMER SERVICE @ 1-800-245-6489. CAUTIONS AND WARNINGS: READ THESE INSTRUCTIONS CAREFULLY BEFORE INSTALLATION CAUTION: This unit must be installed in accordance with these instructions and must comply with local building and fire codes. Failure to do so could result in a chimney or house fire, property d

Page | 34 YEARLY MAINTENANCE YEARLY MAINTENANCE Checking Gaskets An airtight seal at the door openings and hopper lid opening is crucial to proper stove performance. Any air leaks at these areas can not only cause a dirty, inefficient burn but can also pose a serious safety threat. Because of this, gaskets should always be maintained in good condition. Gasket tightness can be checked using the “dollar-bill” method: . Place a dollar bill between the gasket and the stove body (at the location wher

• The firebox baffle is a free floating design, which reduces thermal stresses on the baffle and makes it easily removable for cleaning. • Remove the baffle by: o Grasping the baffle lifting tab in the center of the baffle. o Tilting the baffle towards the back of the stove. o Lifting the baffle up and out of its support holes on the firebox shelf. o Allowing the baffle to slide down to the cradle and then tilting it down and pulling it out of the stove through the main loading door. • As soon a