This device may not cause harmful interference. 2. This device must accept any interference, including interference that may cause undesired operation. INTRODUCTION The WR-3000 receiver can be used with any of the Dakota Alert 3000 series transmitters ( WMT-3000, WPT- 3000, WHT-3000) . The WR-3000 plugs in to a standard wall outlet and can be placed on a table or mounted on the wall. When the receiver gets a signal from the transmitter one of 4 different tones (Classical , Westminster Chime, Din

2 Installation Caution and Warnings ............................................................................................... 3 Control Module and Components ............................................................................................. 3-4 Mounting Location………………………………………..................................................................4-5 Installations...........................................................................................................................

The holder accepts a 1/ 4-inch striped stranded wire. Tighten the fuse holder ends by securely tightening by hand. *Improper connection could result in numerous “Start up test” notifications, and increased usage on monthly billing. Powering the Unit for the First Time *Disconnect the backup battery if it is installed. Connect the two coax cables from the combo antenna (securely) and connect the vehicle’s 12-volt power and observe the LED on the Module. During the initial 15 minutes after +12 vol

OF PIXELS H 510 5СЮ V 492 582 SCANNING FREQUENCY H 15.734”Khz Í5Í625 Khz V 59.94 Hz 50 Hz HORIZONTAL RESOLUTION 380 TV Lines 380 TV Lines SHUTTER SPEED 1/60-1/100,000 see 1/50-1/100,000 see IMAGE PICK-UP DEVICE 1/4" IT COLOR CCD Image Sensor SCANNING SYSTEM 2:1 Interlaced SYNC. SYSTEM Internal S/N RATIO (AGC off) More than 48 dB MIN. SENSITIVITY 0.5 [ux -at F: 2.0/30 IRE GAMMA CORRECTION 0.45 Approx GAIN CONTROL Automatic VIDEO OUTPUT Composite Video 1.0Vp-p/750hm

z Please make sure the vehicle is well parked in a safe place. Make sure that the engine and the power are switched off. z Avoid installation outdoors during rain or thunder storms. z The instructions presented in this manual are based on the passenger seat at the right of the driver’s seat. In an opposite situation, change the directions accordingly. z Objects on the monitor are closer than they appear. • This I/R camera is not a safety device. Safe driving is the driver’s responsibility in all

Driver’s Side Under dash mounting provides an easy location for wiring most of the system’s connections, however this is a common location for an intruder to check for an alarm after breaking into the vehicle. SIREN: Mount the siren under the hood to an inner fender-well, wheel-well, or other body surface with the open end facing downward. Run the red siren wire through the firewall using a rubber grommet. Ground the sirens black wire to metal near the siren or you can use one of the siren’s mou

4. When you get to the desired option number, quickly press the appropriate button on the remote control according to the chart below. The system will provide 1 chirp/flash for Button 1 (Lock Symbol) and 2 chirps/flashes for button 2, 3 for Button #3 and 4 for button #4. (See Chart below for option descriptions and values.) 5. Turn Ignition off. System chirps and flashes the lights 3 times on exit. When you are finished customizing options, check operation. PROGRAMMING OPTIONS CHART * = Default

If the system is armed, pressing Button 4 may or may not trip the alarm system when opening the trunk depending on programming option #7. See page 8. 12 OPERATING INSTRUCTIONS EMERGENCY OVERRIDE & DISARM If you have lost the transmitter or it stops working for any reason and the Alarm is armed, you will have to perform and Emergency Override to Disarm the Alarm. Open the door with the key, (alarm will sound). Turn the ignition on and press the override/program button 4-5 seconds (until siren sto