The package should contain the following items: • USB-4750 Module • Shielded USB 2.0 Cable (1.8 m) • Companion CD-ROM (DLL driver included) • User Manual The USB-4750 Module harbors certain electronic components vulnerable to electrostatic discharge (ESD). ESD could easily damage the integrated circuits and certain components if preventive measures are not carefully paid attention to. Before removing the module from the antistatic plastic bag, you should take following precautions to ward off po

This feature lets you simply and quickly build an RS-485 network with just two wires. More importantly, application software previously written for half duplex RS232 environments can be maintained without need for modification. UNO-1170 User Manual 10 2.3.4 RS-232/422/485 Selection COM2 and COM3 support 9-wire RS-232, RS-422 or RS-485 interfaces, and you can set corresponding jumpers to select serial ports as RS-232 or RS-422/485 interfaces shown in Table 2.2. Please note to reset the system to

Advantech Co., Ltd. reserves the right to make improvements in the products described in this manual at any time without notice. No part of this manual may be reproduced, copied, translated or transmitted in any form or by any means without the prior written permission of Advantech Co., Ltd. Information provided in this manual is intended to be accurate and reliable. However, Advantech Co., Ltd. assumes no responsibility for its use, nor for any infringements of the rights of third parties, whic

18 3.2 Chassis Grounding .......................................................... 18 Figure 3.1:Chassis Grounding Connection...................18 3.3 Connecting Power ........................................................... 19 3.4 Installing a Hard Disk ..................................................... 19 3.5 Installing a Wireless LAN Card and Antenna................. 20 3.6 BIOS Setup...................................................................... 22 vii Table of Contents Appendi

Please refer to Advantech RMA policy Figure 1.3 Backside of TREK-305R TREK-305R User Manual 4 Power button to control LCD backlight On/Off When LCD backlight is on, red LED light is on Figure 1.4 Front side of TREK-305R Pin definition (on TREK) Connector vendor: 3M Touch systems, p/n: 10226-55G3PC Figure 1.5 26-pin connector Pin definition (on VITA) Connector vendor: 3M Touch systems, p/n: 10236-55G3PC Figure 1.6 36-pin connector 5 TREK-305R User Manual Chapter 1 General Information

Open operator terminals are projected to have the fastest growing revenues and unit shipments over the forecast period 2006 to 2011, with CAGR’s of 10.5% and 12.7% respectively. The worldwide touchscreen operator terminal market represented nearly 70% of total worldwide revenues in 2005, with this percentage set to increase slightly over the forecast period. Open HMI operates with a scalable (and open) operating system (providing standard file formats, interfaces and communications) and can prov

Advantech Co., Ltd. reserves the right to make improvements to the products described in this manual at any time without notice. No part of this manual may be reproduced, copied, translated or transmitted in any form or by any means without the prior written permission of Advantech Co., Ltd. Information provided in this manual is intended to be accurate and reliable. However, Advantech Co., Ltd. assumes no responsibility for its use, nor for any infringements of the rights of third parties which

. Introduction . Installation of Ethernet Driver -for Windows 95 -for Windows 98 -for Windows NT . Further Information CHAPTER 4.1 Introduction The IPPC-9120/9150 is equipped with a high performance 32-bit Ethernet chipset which is fully compliant with IEEE 802.3 100 Mbps CSMA/CD standards. It is supported by major network operating systems. It is also both 100Base-T and 10Base-T compatible. The medium type can be configured via the RSET8139.exe program included on the utility disk. The Ethernet

The options are: 3 (Default), 1. Serial Port 1/2/3/4 IRQ The IRQ of serial port 1/2/3/4 can share the same one or not. The options are: 4/3/10/5(default), 4/3/3/3, 4/3/10/10, 4/3/4/3, share 3, share 3, share 4, share 5, share 10 (share IRQ is reserved). Vector Hi/Low select (Reserved) You can select the interrupt vector level. The options are: low (default), high Vector Address Decoder (Reserved) You can choose the interrupt vector address, the default is 200. 9.11 Password Setting To enable the