Always be aware of overhead power lines. 27. Always keep a firm grip on both handles when motor is running: one hand grasps the front “loop” handle while the other hand grasps the rear handle. Severe injuries can result if you try to use this machine with only one hand or with an insecure grip. 28. Thoroughly inspect the area where equipment is to be used and removed all objects, which can be thrown by the machine. 29. Always keep area clear of children, pets, and bystanders. 30. Always inspect

The gloves also help reduce the transmission of machine vibration to your hands. 2 PROTECTING OTHERS PHYSICAL CONDITION Spectators, children, fellow workers and animals must be warned to come no nearer than 33 feet while the trimmer is in use. People working in the area near you should wear the same protective equipment as the operator. AVOID DAMAGE TO TRIMMER • If the trimmer is operated for extended periods in high temperatures, the drive shaft housing may become very hot (too hot to tou

Replace any missing or illegible safety decals. Inspect for any damaged or worn parts and replace before next use. Store the Rough Cut Mower in a dry environment. 16 MAINTENANCE 1. Periodically check and maintain proper gear oil level. 2. Approximately every 8 hours, grease spindles (3), roller axle (1), wheel forks (4), wheel axles (4), PTO shaft universal joints (2), and PTO telescoping surface. NOTE: Use a high-temp/multi-purpose grease. 3. Before each use check to make sure all safety

Do not allow anyone to operate or assemble this equipment until they have read this manual and have developed a thorough understanding of the safety precautions and operation. Review safety instructions with all users annually. • This equipment is dangerous to children and anyone unfamiliar with its operation. The operator should be a responsible, properly qualified and physically able person familiar with farm machinery and competent in this equipment’s operation. • Never exceed the limits o

Mower not level side to side, uncut or partially cut grass. 2. Blades dull or bent. 3.Carrier RPM too low. 4. Field conditions are so wet that the tractor tire is pushing grass into mud. 5. Ground speed too fast. 6. Blades lock back. 7. Blades riding up due to blade bolt wear or loose bolts. 8. Grass is down from previous weather conditions, 9. Possible build up of marerial under mower. Level 3 pt. Hitch linkage on tractor. Sharpen or replace blades. Use correct PTO speed. Too wet to

FAILURE TO DO SO COULD RESULT IN SERIOUS INJURY. (UECHO INTRODUCTION INTRODUCTION Echo Weed and Grass Trimmers, Models GT-1100 and GT- 2400 are light-weight, high-performance, gasoline powered units designed for grass trimming. WARNING A DANGER ECHO supplies an operator’s manual and safety manual with each product. You must read and understand both manuals before you are can operate your ECHO product safely and effectively. The operator’s manual provides information necessary for operatio

Unauthorized modifications can lead to premature failure of your trimmer or trimmerhead and cause serious personal injury. adVerTenCia PeLigrONo trate de efectuar ajustes ni modificaciones que no esten indicados en el manual del operador de la recor- tadora o en esta hoja de instrucciones. Las modificaciones no autorizadas pueden provocar fallas prematu- ras de la recortadora o del cabezal de la recortadora y causar lesiones personales graves. aVerTiSSeMenT dangerNe pas essayer d’effectuer des r

Tighten and/or replace as needed. • Inspect fuel lines, tank and area around carburetor for fuel leaks. DO NOT operate unit if leaks are found. • Never adjust blades when the engine is operating. • Inspect hand guard for damage. Replace if damaged or missing. • Check that the blade assembly is firmly attached and in safe operating condition. Dull, loose or damaged blades should not be used. DETERMINE OPERATION AREA • Before starting the unit, equip yourself and fellow workers in the 4.5 m (15 ft

If a tachometer is available, idle speed should be set to the specifications found on page 12 "Specifications" of this manual. B C A C WARNING DANGER When carburetor adjustment is completed, blades should not move at idle, otherwise serious personal injury may result. 24 24 CARBURETOR ADJUSTMENT Non Emissions Models Level 2 Tools required: Screwdriver with 2mm blade width, Tachometer (ECHO P/N 99051130017) Parts Required: None NOTE If carburetor has limiter caps follow "Carburetor Adjustment" pr