Оценок - 3, средний балл: 4
(
)
)
|
Фрагмент инструкции
The fully upright position should only be used for a child that is at least 6 months old. • To place the seat in the upright position, push the bar on the rear of the seat toward the front of the stroller and rotate the seatback towards the front of the stroller until this bar is locked in its LOWEST position. See Figure 19. • To recline the seat, pull the bar on the rear of the seat toward the rear of the stroller and rotate the seatback down until this bar is again in its LOWEST position. See Figure 20. Figure 19 Figure 0 WARNING Whether the seatback is upright or reclined, ALWAYS make certain that the rotating bar behind the seatback is in its LOWEST position before placing the child into the seat. The Big Caboose Stand-On Triple Instruction Manual Page 9 Securing a Rear Standing Child • Push the bench seat to its most forward position. • Position the canopy to its most forward position. • Position the child on the platform on the back of the stroller. Be sure that the child is facing forward and BOTH of their hands are holding the handles on the frame. • Position the safety strap behind the child and engage the buckle. See Figure 21. Adjust the strap so that it is snug against the child’s back. • Be sure that BOTH of the child’s feet are fully on the platform at all times. • You may need to adjust the position of the seatback to allow for more room for the child to stand. WARNING The rear stand-on platform and the rear bench seat are designed for a child that is at least -1/ years old but LESS than 0 inches tall. NEVER allow a standing child to use the canopy as a hand hold. Use of the stroller with three children weighing more than 0 pounds each, or children totaling more than 1 0 pounds, will cause excessive wear and stress on the stroller and may cause a hazardous unstable condition. NEVER use this stroller to carry more than children at the same time. Figure 1 Page 10 The Big Caboose Stand-On Triple Instruction Manual Using the Rear Bench Seat • Push the bench seat to its most rearward position. • Position the canopy to its most forward position. • Have the child sit on the bench seat facing backward with their feet on the platform. • You may need to adjust the position of the seatback to allow for more room for the child to sit. • Unlatch the seat belt buckle by squeezing both prongs of each male buckle of the waist strap. • Place the crotch strap between the child’s legs. • Bring both ends of the seat belt around the child’s waist and insert both male end of the seat belt buckle into the female buckle. Insure that it snaps into place. See Figure 22. • Adjust the seat belt to be snug around the child’s waist. • Be sure that the BOTH of the child’s feet are fully on the platform at all times. • Be sure that BOTH of the child’s hands are holding the handles on the frame. WARNING NEVER allow a rear seated child to use the canopy as a hand hold. Storage Basket The maximum weight that can be carried in the storage basket is 10 pounds. Excessive weight may result in a hazardous unstable condition. You can access the storage basket by sliding the rear bench seat forward or backward. Figure The Big Caboose Stand-On Triple Instruction Manual Page 11 Using the Stroller as an Infant Car Seat Carrier The Big Caboose will accommodate a car seat carrier in EACH of the front seating locations. Follow the same instructions for each seat if two car seats are to be installed. • To use the stroller to carry an infant car seat carrier, you must replace the Child Tray with the Car Seat Carrier Support. • Remove the Child Tray by pressing in on the lock tabs and pulling the tray off the brackets. Store the tray in a convenient place for later use. • Line up the female fittings on the Car Seat Carrier Support to the male fittings on the front of the stroller and push inward until the fittings snap into place. See Figure 23. Pull outward on both sides of the support to be sure both are snapped securely in place. • Push the canopy to its most rearward position. • Adjust the seatback to its reclined position. • Remove the infant carrier from the car seat base. • Place the infant carrier onto the top of the stroller in a REAR FACING POSITION, locating the head end of the carrier so that it rests on the Car Seat Carrier Support and the feet end of the carrier so that it rests on the seatback, but NOT on top of the edge of the seatback. See Figure 24. • Insure that the head end of the infant carrier is pushed down firmly INSIDE the frame of the Car Seat Carrier Support and that it is centered side to side. • Remove the carrier restraining straps from the pouches on both sides of the stroller. Buckle them in place over the LOWEST part of the carrier sides. Adjust the straps so Figure Figure Figure they are tight around the carrier but AWAY from the child’s neck. Pull up on the carrier to be sure it is held on securely. See Figure 25. • Always check frequently to be sure that the restraining straps are tight across the infant ca...
Эта инструкция также подходит к моделям:Детские коляски - 431 (386.57 kb)
Детские коляски - 437 (386.57 kb)