Following Picture Disappear Five Seconds later. $ Blue Tooth No Connected II. Power on Bluetooth Function on Mobile phone. Press "Search" (on mobile phone) and “PAIR”(on monitor). Find following picture on monitor. $ Blue Tooth Pairing..... III. CL-706H Appears on Mobil Phone after successful scanning. Connection will start after “8888” Pass Code is entered. Following picture appears after connection. $ Blue Tooth Pairing Complete IV.Connection succesfully after “BEEP” is Heard: Following

Most of the remote start features can be controlled through an existing factory or aftermarket remote keyless entry or alarm system. Pressing an auxiliary button on an Aftermarket system or pressing a button 3 times on a Factory keyless remote can activate a remote start using the 901. This is referred to in this manual as activating the “Green Start input wire”. *IMPORTANT INFORMATION: Primary and Optional Features -PRIMARY: These are features that must be connected in order for the system to o

is flashing or the vehicle will not start. REMOTE ENGINE CONTROL REMOTE ENGINE STARTING - SUCCESSFUL START: 1) Press remote start button or for RS901 model activate Green Start input wire. 2) Parking lights flash once, then turn on solid, Ignition/Acc On. 3) After 6 seconds Starter Motor engages, Parking lights and Acc circuits turn off while cranking. 4) Engine Starts and Runs. Parking Lights and Acc turn back on, Doors Lock. 5) Engine will remain running for programmed run time until reset wit

Parking lights will turn off. Then drive away. FLASH 2X START IGN OFF SOLID UNLOCK REMOTE ENGINE CONTROL REMOTE ENGINE CONTROL INFINITY RUN MODE (RS900 ER III ONLY) This mode can only be engaged when "Idle Down" is being engaged. It allows the vehicle engine to remain running INDEFINITELY after the programmed run time elapses. This mode will allow the vehicle to be left running and unattended without the ignition key in the switch preventing the vehicle from being stolen. This mode can be benefi

BROWN WIRE: (+) SIREN OUTPUT (3 Amp Max.) Connect to RED siren wire from the Siren in the engine compartment. WHITE WIRE: PARKING LIGHT OUTPUT: +12V or (-) Negative Ground (Jumper Selectable) Connect to switched +12V parking light wire at back of light switch. If this is not possible, connect directly to one of the parking lights at the front of the vehicle. If your vehicle requires a (-) Negative Ground signal to activate the parking lights, then you have to move the jumper located on the circu

This booklet contains the information necessary for installing, using, and maintaining your alarm system. If any questions arise, contact your installation dealer or Crimestopper Security Products Inc. at the Tech Support number below. *IMPORTANT INFORMATION: Primary and Optional Features: -PRIMARY: These are features that must be connected in order for the system to operate properly; i.e. the Siren, +12V Power, Ground, Door pin, Flashing lights, LED/Valet Pod etc. -OPTIONAL: These are features

DISARMING BUTTON 2 BUTTON 1 BUTTON 1 + 2 = BUTTON 4 (NO BUTTON 3 WITH WATCH) To disarm the alarm and unlock the doors, press the #2 Button on either transmitter. You will hear 2 siren chirps and the lights will flash twice. The in-dash LED stops flashing dome light turns on. (Optional) If the alarm is tripped, then the #2 Button will have to be pressed twice. The first press will reset the trigger and the second press will Disarm. OPERATION OPERATION ALARM CYCLE RESET If and when the alarm syste

(Toggle not included) See programming option #13 on page 10 to enable this type of starter disable. CUTSTART WIRESTARTERORANGEIGNSWITCHORANGEORANGEN/ CN/ OCOMNOTE ALIGNMENT OF PLUGN/ C = NORMALLY CLOSEDNORMALLY CLOSED STARTER DISABLE (DEFAULT) CUTSTART WIRESTARTERORANGEIGNSWITCHORANGEORANGEN/ CN/ OCOMNOTE ALIGNMENT OF PLUGN/O = NORMALLY OPENHIDDEN TOGGLESWITCH**JUMPER # 7 MUST BEREMOVED! ** (NOT INCLUDED) NORMALLY OPEN STARTER DISABLE (OPTIONAL) Text Box: 8 SYSTEM WIRING DIAGRAM 873087308730IGNI

This booklet contains the information necessary for installing, using, and maintaining your 2004TW1 or 2004DC alarm system. any questions arise, contact your installation dealer or Crimestopper Security Products Inc. at the Tech Support number below. This installation book is designed for the installer or with an existing understanding of automotive systems, along with the ability to test and connect To ease installation, we suggest that you READ THIS MANUAL before beginning your This book is pr