Оценок - 2, средний балл: 3.5
(
)
)
|
Фрагмент инструкции
Parking lights will turn off. Then drive away. FLASH 2X START IGN OFF SOLID UNLOCK REMOTE ENGINE CONTROL REMOTE ENGINE CONTROL INFINITY RUN MODE (RS900 ER III ONLY) This mode can only be engaged when "Idle Down" is being engaged. It allows the vehicle engine to remain running INDEFINITELY after the programmed run time elapses. This mode will allow the vehicle to be left running and unattended without the ignition key in the switch preventing the vehicle from being stolen. This mode can be beneficial to law enforcement, commercial, or work trucks that need to remain running unattended for long periods of time. INFINITY RUN MODE – EXITING THE VEHICLE: (NOT AVAILABLE ON RS901) 1) Have engine running with the Key, then press the Start button on the transmitter once, pause a few seconds, then press the remote start button a second time. 2) Parking Lights will start flashing, and doors will unlock. 3) Turn Ignition switch OFF, remove key and exit the vehicle. Engine should remain running. 4) The vehicle’s parking lights will flash for the programmed run time of 12, 24, or 36, or 48 minutes and then switch to solid while motor runs indefinitely or until fuel supply runs out. IGN OFFSTART FLASH FOR PROGRAMMED 2X RUN TIME, THEN SOLID TIMED SELF START MODE This mode allows the vehicle to be programmed to self-start every 4 hours and run for the programmed run time. This can be helpful during extremely cold conditions where engine fluid freeze-up is a concern. Be sure that the vehicle is outdoors or in a well ventilated area. Once the timed self-start mode is set, the unit will start every 4 hours and run for the programmed time. To reset this mode either start the vehicle with the key or via remote control. REMOTE ENGINE CONTROL REMOTE ENGINE CONTROL TIMED SELF-START MODE – EXITING THE VEHICLE: 1) Have engine running with the Key, then press the Start button or for RS901:model activate Green start input wire. 2) Within 10 seconds press the valet/program button once. 3) Parking Lights will turn OFF for about 5 seconds, and doors will unlock. 4) Turn Ignition switch OFF, remove key and exit the vehicle. Engine should remain running. 5) To turn off the engine, press the remote start button or for RS901 model activate Green Start input wire. The parking lights will flash 4 TIMES as a confirmation that the unit is in Timed Self-Start Mode. 6) The Vehicle will Start by itself every 4 hours until driven with key or started via remote control. CONVENIENCE AND SAFETY FEATURES OEM INTERFACE: (FACTORY UPGRADE) The RS901 Series III Expansion Module includes a programmable interface feature that allows control of most remote start features through an existing factory remote keyless entry system. The RS901 Expansion module can be installed as an upgrade to a Factory Keyless Entry System. This is referred to in this manual as activating the Green Start input. Pressing a button on the Factory remote 3 times will activate a start. This type of installation is usually connected to the lock circuit in the vehicle, therefore pushing the lock button on the Factory Remote 3 times will produce a remote engine start or turn off a remote started engine. PASSIVE STARTER DISABLE: This RS900/901 Series III includes a programmable feature to allow the Optional Starter Disable to activate automatically 1 minute after the ignition is turned off. This feature may provide insurance discounts or meet insurance requirements in your providence. KEYLESS ENTRY (POWER DOOR LOCK CONTROL) This system enables you to remotely lock and unlock the vehicle’s doors (if equipped with power locks) through the transmitter for safety and convenience. This feature may require extra labor and/or parts to install. REMOTE LOCK / UNLOCK 1) Press the Lock or Unlock transmitter button as you leave or come near the vehicle. 2) Parking lights will flash twice for unlock and once for lock. If vehicle is remote started, engine will remain running and lights will flash but return to solid indicating engine is still being controlled by the remote starter. NOTES: Doors lock automatically when vehicle is Remote Started. Starter Disable/Anti-grind is also enabled/disabled with the lock/unlock buttons. If an anti-grind/starter kill relay is installed on a vehicle without power door locks, the lock and unlock buttons on the remote control must still be utilized to operate the Starter disable. CONVENIENCE AND SAFETY FEATURES REMOTE TRUNK RELEASE (OPTIONAL) This feature, if installed, will remotely release a factory electronic trunk or hatch through the transmitter. This feature may require extra labor and/or parts to install. To operate, press Button #3 (Trunk) release button to remotely open trunk or hatch. VALET MODE / STARTER DISABLE OVERRIDE Before servicing your vehicle or handing the keys over to a Valet we recommend putting the unit into valet mode. The remote start function WILL NOT operate when in Valet mode. To enter Valet mode, turn the key to the ON position, press and hold...
Эта инструкция также подходит к моделям:Двери и окна - COOL START RS-901 (103.55 kb)