Important ! The dryer should be located where a minimum amount of exhaust ducting will be necessary. The dryer must be installed with adequate clearance for air openings into the combustion chamber. Caution ! This dryer produces combustible lint and must be exhausted to the outdoors. Every 6 months, inspect the exhaust ducting and remove any lint buildup. Important The dryer must be installed in a location/ ! environment, which the ambient temperature remains between 40° F (4.44° C) and 130° F (

-WHAT TO DO IF YOU SMELL GAS: • Do not try to light any appliance. • Do not touch any electrical switch; do not use any phone in your building. • Clear the room, building or area of all occupants. • Immediately call your gas supplier from a neighbor's phone. Follow the gas supplier's instructions. • If you cannot reach your gas supplier, call the fire department. Installation and service must be performed by a qualified installer, service agency or the gas supplier. ©1996 White Consolidated Indu

3 Lower Front Panel Removal ............................................................. 3 Upper Front Panel Removal ............................................................. 3 Top Cover Removal ......................................................................... 3 Lint Box/Blower Assembly Removal ................................................. 4 Gas Valve/Ignition System Removal ................................................. 5 Oven Chamber Removal ................................

Wiring errors can cause improper and dangerous operation. Please post in a prominent location. Instructions to be followed in the event the user smells gas. The information posted shall be obtained by consulting with your local gas supplier. The wiring diagram for the dryer is located in the front electrical control box. 1 This product embodies advanced concepts in engineering, design and safety. If this product is properly maintained, it will provide many years of safe, efficient, and troub

Or the dryer that means you can shrug off the weather, forget the rain, and dry a mountain of clothes in no time at all. The things you take for granted...until they fail to deliver just when you need them most. It’s hardly surprising then that people choose Admiral. For 70 years Admiral has designed appliances that attract admiring looks, but whose sleek and classic exteriors conceal workhorse performance and show horse finesse. Appliances that pack in more reliability, practicality and robustn

The dryer must be isolated from the gas supply piping system by closing its individual manual shutoff valve during any pressure test of the gas supply piping system at test pressures equal to or less than 1/2 psig (3.5 kPa). IMPORTANT: Failure to isolate or disconnect the dryer from supply as noted can cause irreparable damage to the gas valve, which will VOID THE WARRANTY. WARNING: FIRE OR EXPLOSION COULD RESULT. 1. Gas Supply The gas dryer installation must meet the American National Standard.

The condensate tank has a volume of approx. 4 litres. This is sufficient for around 7kg of laundry which has previously been spun at 1000 revolutions/ minute. The condensate can be used as distilled water, e.g. for steam ironing. However first filter the condensate (e.g. with a coffee filter) to remove any residue and small pieces of fluff. Cleaning heat exchanger If the warning led is lighting, the heat exchanger needs to be cleaned. CAUTION! Operating when the heat exchanger is blocked with fl

Experience drying on a whole new level. 88 Currant Road Fall River, MA 02720 P: 508.678.9000 F: 508.678.9447 2.5M 450264 6/06 Solaris improves the state of commercial drying in virtually With its multi-functional diagnostics, the Solaris microprocessor monitors the entire dryer to maximize performance, increase operational efficiency and reduce downtime. It reports dryer service needs via a scrolling display that can reduce guesswork and service time. It can also alternate messages between two l