Battery condition will affect the ability of the machine to climb a slope. Genie Z-34/22 & Genie Z-34/22N PartNo.43654 Second Edition • Ninth Printing Operator's Manual Driving on a slope Determine the uphill, downhill and side slope ratings for the machine and determine the slope grade. Maximum slope rating, counterweight uphill (gradeability): 20% (11°) Maximum slope rating, counterweight downhill: 20% (11°) Maximum side slope rating: 20% (11°) Note: Slope rating is subject to ground condition

That means every new operator should perform a pre-operation inspection, function tests, and a workplace inspection before using the machine. Genie Z-34/22 & Genie Z-34/22N PartNo.43654 Second Edition • Ninth Printing Operator's Manual Emergency Stop Push in the red Emergency Stop button to the off position at the ground or platform controls to stop all machine functions. Repair any function that operates when the red Emergency Stop button is pushed in. Selecting and operating the ground control

82258 Genie Z-80/60 27 First Edition · Fifth Printing Operator's Manual DECALS 33952 32700 65269 28236 28176 30080 28163 or 44986 82296 28174 or 28235 28175 28164 28171 Serial Plate 28160 27564 28161 82202 or 82203 or 82204 82296 133400 133400 43595 43595 28165 82281 28174 or 28235 52966 or 52967 82312 27205 27204 82269 28161 82296 43595 31060 27206 27206 65278 65278 65278 65278 27207 27207 40434 28177 40434 28181 28177 82366 32700 65269 27564 31060 28161 28158 or 28159 82268 72169 72168 82403 1

Using the machine for anything other than lifting personnel, along with their tools and materials, to an aerial work site is unsafe and dangerous. Only trained and authorized personnel should be permitted to operate a machine. If more than one operator is expected to use a machine at different times in the same work shift, they must all be qualified operators and are all expected to follow all safety rules and instructions in the operator's, safety and responsibilities manuals. That means every

Use a minimum of 4 chains. Adjust the rigging to prevent damage to the chains. Securing the Platform Make sure the jib and platform are in the stowed position. Place a block under the edge of the platform beneath the platform entry. Secure the platform with a nylon strap placed over the platform mount near the platform rotator (see below). Do not use excessive downward force when securing the boom section. First Edition • Fifth Printing Operator's Manual Observe and Obey: Only qualified riggers

82900 with Maintenance Information Operator's Manual First Edition • Sixth Printing Important Read, understand and obey these safety rules and operating instructions before operating this machine. Only trained and authorized personnel shall be permitted to operate this machine. This manual should be considered a permanent part of your machine and should remain with the machine at all times. If you have any questions, call Genie Industries. Contents Page Safety ...................................

Charging the Batteries with the AC Charger 1 Be sure the engine (if equipped) is turned off. 2 Be sure the batteries are connected before charging the batteries. 3 Open the machine covers. The covers should remain open for the entire charging cycle. 4 Remove the battery vent caps and check the battery acid level. If necessary, add only enough distilled water to cover the plates. Do not overfill prior to the charge cycle. 5 Replace the battery vent caps. 6 Connect the battery charger to a grounde