– Line Type: the type of DS1 Line implemented on this circuit. The type of circuit affects the number of bits per second that the circuit can reasonably carry, as well as the interpretation of the usage and error statistics. Select fromt he following values: • other(1)—Link is disabled • dsx1ESF(2)—Extended Superframe DS1 • dsx1D4(3)—AT&T D4 format DS1 • dsx1E1(4)—Based on CCITT/ITU G.704 without CRC (Cyclical Redundancy Check) • dsx1E1-CRC(5)—Based on CCITT/ITU G.704 with CRC (Cyclical Redundan

7622 Rickenbacker Drive Gaithersburg, MD 20879 USA Tel: +1 (301) 975-1000 Fax: +1 (301) 869-9293 Support: +1 (301) 975-1007 Web: E-mail: support@patton.com Trademark Statement The terms SmartNode, SmartWare, and SmartView are trademarks of Patton Electronics Company. All other trademarks presented in this document are the property of their respective owners. Copyright © 2012, Patton Electronics Company. All rights reserved. The information in this document is subject to change without notice. Pa

Connect the SmartNode to the network............................................................................................................42 3. Load configuration............................................................................................................................................42 Bootloader.............................................................................................................................................................43 Start Bootloader ..

4 List of Figures ............................................................................................................................................... 10 List of Tables ................................................................................................................................................ 12 About this guide ........................................................................................................................................... 13 Audience....

Ensure that your site is properly prepared before beginning installation. Before installing the gateway router device, the following tasks should be completed: •Create a network diagram (see section “Network information” on page 30) •Gather IP related information (see section “IP related information” on page 30 for more information) •Install the hardware and software needed to configure the SmartNode. (See section “Software tools” on page 30) •Verify power source reliability (see section “Power

It is not intended nor approved for use in an industrial or residential environment. Caution—This device is not intended nor approved for connection to the public ISDN telecommunication network. Attention—Ce dispositif n'est pas prevu ni approuve pour le raccordement au reseau de telecommunication public le RNIS. Vorsicht—Dieses Gerat ist nicht fur Anschaltung an das offentlich ISDN Telekommunikationsnetz genehmigt. Precaucion—Este dispositivo no esta previsto ni se ha aprobado para la conexion

122 Ethernet Cable ....................................................................................................................................................123 Adapter................................................................................................................................................................123 D IPLink Physical Connectors ....................................................................................................................... 124 RJ-45

Verify that the proper voltage is present before plugging the power cord into the receptacle. Failure to do so could result in equipment damage. 3. Verify that the AC power cord included with your IPLink router is compatible with local standards. If it is not, refer to chapter 13, “Contacting Patton for assistance” on page 112 to find out how to replace it with a compatible power cord. 4. Connect the male end of the power cord to an appropriate power outlet. 5. Verify that the green Power LED is