My local “Pelpro” dealer is: Manufactured by: Contact local building or fire officials about restrictions and installation inspection requirements in your area. Toll Free Technical Support 1 - 866 -456 -9269 To register your purchase FPP Bay View Freestanding IPP Bay View Insert / Built-In FPP Freestanding IPP Insert / Built-In READ THIS ENTIRE MANUAL BEFORE YOU INSTALL AND USE YOUR HEATER. FAILURE TO FOLLOW INSTRUCTIONS MAY RESULT IN PROPERTY DAMAGE, BODILY INJURY OR EVEN DEATH! Installation sh

Floor protector needs to be a minimum of 24.5” deep X 30.5” wide and be a minimum of .018” thick (26 gauge). Must extend under and 2” to each side of chimney tee (if used). MINIMUM CLEARANCES TO COMBUSTIBLES (Figures 12-17) 1” From Back Of Heater to Combustibles 3” From PL Vent to Combustibles 10” From Front Side of Heater to Combustibles 1” From Back Corner of Heater to Combustibles 6” Non Combustible Surface In Front Of Heater 16” From Top Of Heater to Combustibles 36” to drapes, doors, anythi

Acids that are found in many common foods and meats can also act as a corrosive on most finishes. A paint grade finish may require a periodic sanding and a touch-up painting once a season to maintain that just new appearance. Louisiana Grills uses a Black color, “Stove Bright” brand, High Heat BBQ Paint. This can be purchased from your local dealer or through Louisiana Grills. This paint is a silicone epoxy base and is designed for up to 1100°F (600°C) .Paint Grade allows flexibility in the colo

To INCREASE fuel rate turn trimmer COUNTER CLOCKWISE and to LOWER turn CLOCKWISE. To assist in knowing what changes you made, you should note the amount of time the light on the AUGER CYCLE stays “OFF”. (Note: The light stays “off” when ever the fuel feed motor is not running). Lengthening the time this light stays “OFF” lowers the fuel feed and shortening the “OFF” time increases the fuel feed. Factory Setting #1 light “OFF” is approx. 9-11 seconds, #4 light “OFF” is 3-4 seconds. FEED RATE STAR

You have selected the finest in residential wood pellet heating technology. This OPERATIONS GUIDE will walk you through the initial setup of your pellet stove, from first light to fine tuned adjustments. We have also included detailed information on cleaning and maintenance as well as wood pellet fuel facts. Please note the following points regarding stove installation and pellet heating in general: - Whether you install your stove yourself or hire a professional installer, a quality installatio

The FAN speed can be adjusted by adjusting the FAN trim pot COUNTER CLOCKWISE to INCREASE the speed and CLOCKWISE to DECREASE the speed of the combustion fan. Note: If you attempt to adjust the Fuel Feed Trim Pots, use a small precision screwdriver. The Trim Pots do not make a full rotation. If using a metal screwdriver, be gentle as the plastic trim pot slot can be damaged or stripped. FAN SPEED (Convection or heating) The FAN SPEED controls the speed of the room air fan. This fan blows room ai

Connect the 2 wires at your wall thermostat to their terminals. Ensure the wires are firmly connected 10. Reinstall the 9 pin wire harness to the 9 pin plug now found on the thermostat module 11. Reinstall the control board and the slotted rear access panels 12. Plug in the stove and you are ready to operate with your thermostat asdesred IMPORTANT: PLEASE READ BEFORE STARTING YOUR STOVE The controller on your stove has been fitted with memory. Should you have a power outage or blip, the unit wil