4-5 4.3 Using the RESET Button................................................................................. 4-7 A SPECIFICATIONS A.1 Module Specifications .....................................................................................A-1 A.2 Physical Properties .........................................................................................A-1 A.3 Environmental Requirements..........................................................................A-1 A.4 Input/Output Ports ....

The cord is secured to the side of the ANG-11xx with an adhesive clip, as shown in Figure 1. Simply attach the clip an inch or so to the left of the power connector of the ANG-11xx. Then attach the cord to the clip and plug into the unit. Figure 1 Power Kit Installation 9038127 Page 1 of 2 Contacting Enterasys Networks Application Note ANG-11xx Power Kit Contacting Enterasys Networks For more information about Enterasys Networks, consult the following table: U.S. Office Address 35 Indu

The reader should in all cases consult Enterasys Networks to determine whether any such changes have been made. The hardware, firmware, or software described in this document is subject to change without notice. IN NO EVENT SHALL ENTERASYS NETWORKS BE LIABLE FOR ANY INCIDENTAL, INDIRECT, SPECIAL, OR CONSEQUENTIAL DAMAGES WHATSOEVER (INCLUDING BUT NOT LIMITED TO LOST PROFITS) ARISING OUT OF OR RELATED TO THIS DOCUMENT, WEB SITE, OR THE INFORMATION CONTAINED IN THEM, EVEN IF ENTERASYS NETWORKS HAS

In the 802.1Q mode (the default mode of operation), the module functions as an 802.1D switch until you configure VLANs. Up to 1024 VLANs can be configured. IEEE 802.1Q switching allows migration to Virtual Network technologies without requiring the replacement of existing equipment. 1.10 STANDARDS COMPATIBILITY The 5H102-48 and 5H103-48 modules are fully compliant with the IEEE 802.3, 802.3u, 802.3x, 802.1D, and 802.1Q standards. The modules provide IEEE 802.1D Spanning Tree Algorithm (STA) supp

If the Licensed Materials are exported from the United States pursuant to the License Exception CIV under the U.S. Export Administration Regulations, You agree that You are a civil end user of the Licensed Materials and agree that You will use the Licensed Materials for civil end uses only and not for military purposes. If the Licensed Materials are exported from the United States pursuant to the License Exception TSR under the U.S. Export Administration Regulations, in addition to the restricti

Detection .The user.s end.system connects to the network and transmits data traffic onto the network that traverses the NAC Controller. This traffic is sourced from a MAC address or IP address not previously seen by the controller. 2. Authentication .One of two configurations may be implemented on the NAC Controller for end user authentication. Authentication can be disabled altogether, trusting that the downstream infrastructure devices authenticated the end.system to the network (802.1X authen