After 20 seconds of inactivity, a feature of the fireplace is for the LED visuals on the touchpad control panel to go out. You must activate the fireplace electronics by depressing any buttons on the remote control or the touchpad control panel for the LED visuals to reappear before any settings can be made or changed. Figure 10 Figure 11 3 3 B A 6 1 4 2 5 I/O I/O 4 7 1 FP1614 2 6 5 7 FP1614 VCEF touchpad FP1615 4/06 10009816 13 • Flame Speed Control Your fireplace features a flame speed that ca

20000583 7/06 Rev. 20 WMC Series Woodburning Fireplace Safety Information PLEASE READ THIS MANUAL BEFORE INSTALLING AND USING FIREPLACE. IMPORTANT: Read all instructions and warnings carefully before starting installation. Failure to follow these instructions may result in a possible fire hazard and will void the warranty. Description The WMC Series fireplaces are solid fuel, woodburning premium fireplaces. The WMC36/42 are circulating models with removable grilles (louvers). Both models are ful

C and D dimensions for wall/cabinet opening clearance. Units: EFJU4D0, EF0U4F0, EF0U4I0, EF0U4J0, EFJUF50 Electrical Specifications EF22 / EF26/EF26FG EF33 / EF36 Voltage 120V AC, 60 Hz 120V AC, 60Hz Total Amps 12 12.5 Total Watts 1450 1500 Heater Rating 1350 Watts 1350 Watts • Locating Your Fireplace Your new fireplace may be installed in a prefabricated cabinet available from your dealer. When choosing a location for your new fireplace, ensure the general instructions are followed. Also, for b

I/O I/O A 3 2 1 7 B 6 5 4 Fig. 10 HEF22 touchpad buttons. The fireplace features conveniently separate controls for flame effect and for heater control. This allows you to operate the unit in three (3) different modes: • As a full-featured fireplace - both flame effect and heater are on. This mode allows you to enjoy the look of the fire along with the heat output of a heater. I/O I/O 3 A B 6 5 4 2 1 7 8 Fig. 11 HEF26 and HEF33 touchpad buttons. (Button 8 does not apply to HEF22.) • As a visual

Never locate this appliance where it may fall into a bathtub or other water container. 10. Do not run cord under carpeting. Do not cover cord with throw rugs, runners or the like. Arrange cord away from traffic areas and where it will not be tripped over. 11. To disconnect this appliance, turn controls to the off position, then remove plug from outlet. 12. Connect to properly grounded outlets only. 13. This appliance, when installed must be electrically grounded in accordance with local codes, w

Seal Crack Between Fire- place and Hearth Exten- sion with Noncombustible Material FP1172 Fig. 35 Sealing detail. Hearth Extension Installing Line for Gas Logs CFM Corporation fireplaces are designed to accept a 1/2 inch gas line for installation of an approved gas appliance. (CFM Corporation manufactures a wide variety of gas logs for use in CFM Corporation fireplaces.) Be sure to have the appliance installed in accordance with building codes. Gas connection may enter from either left or right

DO NOT STORE OR USE GASOLINE OR OTHER FLAMMABLE VAPORS OR LIQUIDS IN THE VICINITY OF THIS OR ANY OTHER APPLIANCE. C US Electric Fireplace Model: HEF22 HEF26 HEF33 Installation Instructions and Homeowners Manual INSTALLER: DO NOT DISCARD THIS MANUAL - LEAVE FOR HOMEOWNER 10008388 8/06 Rev. 5 STOP!STOP! NO NEED TO RETURN TO THE STORE Questions with the Assembly? Require Parts Information? Product Under Manufacturer’s Warranty? Call Toll-Free US: 1-800-668-5323 Canada: 1-800-668-5323 Monday to Frid

Remove and discard the green wire. Reinstall the nut but do not tighten yet. 7. While standing on the right side of the unit, locate the power cord where it exits the cabinet. Using pliers, gently cut and remove the power cord. Dispose of the power cord. 8. Using a slotted screwdriver, remove the 7/8" (22 mm) diameter knockout from the right hand side of the cabinet above where the strain relief was located. 9. Route the electrical cable from the breaker/fuse panel through the 7/8" (22mm) diamet

• Provide adequate accessibility clearances for servicing and proper operation. • Provide adequate clearances around air openings into the combustion chamber.. • This appliance has a built-in draft hood, so no additional external draft hood is required. • If installing in a factory built fireplace, you may remove the damper, glass doors, screen, screen holder, baffles, and smoke shelf provided that what you take out can be reinstalled. Also you must retain the pieces you have removed, in case so

WARNING! IF THE INFORMATION IN THIS MANUAL IS NOT FOLLOWED EXACTLY, AN ELECTRICAL SHOCK OR FIRE MAY RESULT CAUSING PROPERTY DAMAGE, PERSONAL INJURY OR LOSS OF LIFE. 10010019 4/07 Rev. 3 FOR YOUR SAFETY Service must be performed by a qualified service agency. DO NOT STORE OR USE GASOLINE OR OTHER FLAMMABLE VAPORS OR LIQUIDS IN THE VICINITY OF THIS OR ANY OTHER APPLIANCE. INSTALLER: Leave this manual with the appliance. CONSUMER: Retain this manual for future reference. C US EF28 Electric Fireplac