Оценок - 6, средний балл: 4
(
)
)
|
Фрагмент инструкции
Seal Crack Between Fire- place and Hearth Exten- sion with Noncombustible Material FP1172 Fig. 35 Sealing detail. Hearth Extension Installing Line for Gas Logs CFM Corporation fireplaces are designed to accept a 1/2 inch gas line for installation of an approved gas appliance. (CFM Corporation manufactures a wide variety of gas logs for use in CFM Corporation fireplaces.) Be sure to have the appliance installed in accordance with building codes. Gas connection may enter from either left or right side of the fireplace. Locate appropriate gas line in the outer casing of fire place and remove insulation from gas line tube. (Fig. 36) From inside the fireplace, locate the knockout on the firebrick -- be sure you are on the appropriate or "gas line" side of the fireplace. Using a flat bladed screwdriver or small chisel and hammer, carefully tap around the knockout until it loosens and falls out. Install 1/2 inch certified gas pipe through opening. After gas pipe installation is complete, use insulation that was SHR Series Woodburning Fireplaces removed from gas line tube to repack space around the pipe. Material should be inserted from outside of the fireplace and packed tightly to totally seal between the pipe and tube. NOTE: Gas pipe should not come in contact with any wood structures until it has reached a point at least one (1) inch away from fireplace side. NOTE: When installing an ANSI Z21.11.2 ventless appliance, the finishing material used for the mantel must be rated at 250°F or greater. BTU input of a gas appliance installed in fireplace should be rated less than 100,000 BTU/Hr. Gas pipe installation is intended for connection to a decorative gas appliance only when (1.) incorporating an automatic shutoff device and (2.) complying with the Standard for Decorative Gas Appliances for Installation in Vented Fireplaces (ANSI Z21.60) or CSA draft requirements for Gas-Fired Log Lighters for Woodburning Fireplaces (Draft No. 4, August 1993). Decorative gas appliance should be installed in accordance with the National Fuel Gas Code, ANSI Z223.1/ NFPA 54 (latest edition). CAUTION: WHEN USING DECORATIVE GAS APPLIANCE, FLUE DAMPER MUST BE SET IN FULLY OPEN POSITION. IF YOU HAVE GLASS DOORS ON THE FIREPLACE, THEY MUST ALSO BE FULLY OPENED. WARNING: DO NOT OPERATE AN UNVENTED GAS LOG SET IN THIS FIREPLACE WITH THE CHIMNEY REMOVED. WARNING: WHEN INSTALLING AN UNVENTED GAS LOG SET, THE CFM CORPORATION MODEL AH3244BK OR AH3244PB 4" ADJUSTABLE HOOD MUST BE USED. 1" Min. 1/2" FP560SHR Fig. 36 Gas line access. Hole in Outer Casing Gas Line Tubing Ceramic Knockout Hole in Outer Casing Supply Line Repack Insulation Ceramic Knockout (both sides) If installing an unvented gas log set, refer to statement below: Only unvented gas log sets which have been found to comply with the Standard for Unvented Room Heaters, ANSI Z21.11.2, are to be installed in this fireplace. SHR Series Woodburning Fireplace 1 2 3 4 5 6 7 8 a b c 9 10 11 d 12 13 CFM Corporation reserves the right to make changes in design, materials, specifications, prices and discontinue colors and products at any time, without notice. SHR36/42A/48/52 Woodburning Fireplace For units FH30R0, GH40R0, HH30R0, IH10R0 Ref. Description SHR36 SHR42A SHR48 SHR52 1. Damper Weld Assembly RP210 RP210 RP210 n/a 2. Damper Handle 20001418 20001418 20001418 20005322 3. Screen Rail 20001429 20006021 20001431 20005569 4. Screen Rod (two per fireplace) 7554181 7554199 20001428 20005790 5. Screen (two per fireplace) 7554295 20001723 20001723 20005278 6. Screen Pull (two per fireplace) 5584139 5584139 5584139 5584139 7. Push Nut (two per fireplace) 7512167 7512167 7512167 7512167 8a. Firebrick - Hearth 20001272 20005611 20001172 20005303 8b. Firebrick - Back 20004165 20005610 20004147 20005293 8c. Firebrick - Left Side 20004166 20005612 20004154 20005302 8d. Firebrick - Right Side 20004167 20005613 20004148 20005304 9. Firebrick Retainers (three per fireplace) 20001432 20001432 20001432 20001432 10. Basket Grate 20004203 20004203 20004311 20005433 11. O.S.A. Assy. 20003076 20003076 20003076 20005762 12. Damper Blade Assy n/a n/a n/a 20007536 13. Pivot Rod n/a n/a n/a 20005772 20 20001384 SHR Series Woodburning Fireplaces Accessories The following accessories for this appliance are available from your local Majestic Fireplaces distributor. Should you need additional information beyond what your distributor can furnish, contact: CFM Corporation, 410 Admiral Blvd., Mississauga, Ontario, Canada L5T 2N6 Attn: Technical Services. CAUTION: This fireplace and chimney assembly is a highly engineered system, and, as such, must be operated only with CFM Corporation approved components. If you use an unapproved component to make any modifications, you may create a possible fire hazard and will void the CFM Corporation warranty. In addition, such action may void the coverage provided by the owner’s insurance. Accessory Description Model No. Glass Enclosure Kit Designed to enclose the fireplace opening ...
Эта инструкция также подходит к моделям:Камины - SHR36 (1.39 mb)
Камины - SHR42A (1.39 mb)
Камины - SHR48 (1.39 mb)