READ AND FOLLOW ALL INSTRUCTIONS IN THIS MANUAL AND ANY PROVIDED WITH THE EQUIPMENT ON WHICH THIS ENGINE IS USED BEFORE ATTEMPTING TO OPERATE YOUR TECUMSEH ENGINE. A THESE SYMBOLS MAY APPEAR ON THE ENGINE: FAST SLOW STOP OFF FULL IGNITION KEY INSERT TO RUN REMOVE TO STOP CHOKE California Proposition 65 WARNING: The engine exhaust from this product contains chemicals known to the State of California to cause cancer, birth defects or other reproductive harm. 3-1-00 181-637-14 181-637-14

II. III. IV. V. VI. VII. VIII. IX. X. XI. XII. Safety Definitions ..............................................................................ii General Safety Precautions ............................................................. 1 How to Get Service .......................................................................... 3 Oil and Fuel Specifications............................................................... 4 Before Starting Your Engine..............................................

NOTE: The electric starter is thermally protected. If overheated, it will stop automatically and can be restarted only when it has cooled to a safe temperature (a wait of approximately 5-10 minutes is required). If, after following the preceding instructions, the engine does not start, have it checked by your Authorized Tecumseh Service Outlet. Figure 5 Paae 3 181-637-14 STOPPING • BEFORE STOPPING (see Figure 1): A. Run engine for a few minutes to help dry off any moisture on engine. B.

S. Environmental Protection Agency (“EPA”), the California Air Resources Board (“GARB”) and Tecumseh Products Co. are pleased to explain the Federal and California Emission Control Systems Warranty on your new smaii off-road engine. In California, new 1995 and later small off-road engines must be designed, built and equipped to meet the State’s stringent anti-smog standards. In other states, new 1997 and later model year engines must be designed, built and equipped, at the time of sale, to meet

DO NOT Modify Engine To avoid serious injury or death, DO NOT modify engine in any way. Tampering with the governor setting can lead to a runaway engine and cause it to operate at unsafe speeds. NEVER tamper with factory setting of engine governor. ! WARNING F. Avoid Burns and Fire from Hot Surfaces The muffler and other engine parts become extremely hot during operation and remain hot after the engine has stopped. • To avoid severe burns on contact, STAY AWAY from hot areas of engine. DO NOT op

If any such part fails during the ECS Warranty Period, it shall be repaired or replaced by Tecumseh Power Company according to Subsection 4 below. Any such part repaired or replaced under the ECS Warranty shall be warranted for any remainder of the ECS Warranty Period. 2. Any warranted, emissions-related part which is scheduled only for regular inspection as specified in the Operator’s Manual shall be warranted for the ECS Warranty Period. A statement in such written instructions to the effect o

4-Cycle Snow Engine Components 2 3 7 12 6 8 13 9 10 4 5 2 4 3 7 12 6 8 13 10 1 5 1 3 4 7 12 6 8 13 9 10 2 5 1 9 11 11 OH318SA/OH358SA 1 3 4 8 12 6 7 13 9 10 2 5 OH195SA/OH195SP LH195SA/LH195SP LH318SA/LH358SA E. Filling Fuel Tank !WARNING An adult should fuel this engine. NEVER allow children to refuel this engine. Gasoline (fuel) vapors are highly flammable and can explode. Fuel vapors can spread and be ignited by a spark or flame many feet away from engine. To prevent injury or death from fuel

1. To prevent serious injury from fuel fires, empty fuel tank by running engine until it stops from lack of fuel. DO NOT attempt to pour fuel from engine. 2. Run the engine while waiting until the remaining fuel is consumed. !WARNING NEVER leave the engine unattended when it is running and NEVER run engine in enclosed areas. 3. Begin servicing the cylinder bore. See "II. Oil Cylinder Bore" instructions on page 25. Page 24 4-Cycle • Snow King Engine 181-1275-14 II. Oil Cylinder Bore !WARNING When

Typical Spark Plug Connection File was named: 181-1275-14MY060105x.fm 2. Be sure fuel fill cap is on and tightened securely. See Figure 46. Figure 46. Fuel Fill Cap 3. Be sure you find the correct oil drain plug location (see equipment manufacturer’s instructions). See Figure 47. 4. Clean area around oil drain plug. Figure 47. Oil Fill/Drain Locations STOPSTOP1. Oil Fill Cap/Plug 2. Oil Drain Plug 2 2 Back View 1 2 Angled Front View 1 Page 20 4-Cycle • Snow King Engine 181-1275-14 5. Place appro

READ AND FOLLOW ALL INSTRUCTIONS IN THIS MANUAL AND ANY PROVIDED WITH THE EQUIPMENT ON WHICH THIS ENGINE IS USED BEFORE ATTEMPTING TO OPERATE YOUR TECUMSEH ENGINE. A THESE SYMBOLS MAY APPEAR ON THE ENGINE: A California Proposition 65 WARNING: The engine exhaust from this product contains chemicals known to the State of California to cause cancer, birth defects or other reproductive harm. 2-1-99 181-807-14 SPARK PLUG WIRE SPARK PLUG MUFFLER CARBURETOR STARTER HANDLE RECOIL STARTER SP