Designed for operation, this comp act p pieacek oafg el eisc tbroign inc epqeurfioprmeantc, component s. The circuitry is al solid-st ate and mounted on a rugged printed circuit board. Y our two-way radio is designed foreliable trouble-fre performance for years to come. Features - 22 GMRS/FRS Channel - Call - R-o SgAecarle nBr teF eupn ction T one - Silent Operation - Keyp - Paodw eLro cHkI/LO Setings - Auto Squelch - S - B-a Bteparetytae Lkryeo rwL /i fIMen diEcicxroateptonhrdoenre Jacks intecr

and 19 • Backlit LCD - 1 - Index Introduction 3 Package Includes 4 Installing the Batteries 5 Quick Start (Portable) 6 Quick Start (Mobile) 7 Controls and Indicators 8 Functions and Controls 9-10 LCD Indicators 11 CB Specifications 12 Weather Receiver Specifications 13 CB Accessories 14 Accessories Order Form 15 Warranty Information 16 MIDLAND Family Products 17 - 2 - Introduction Your 75-822 represents the state-of-the-art in high-tech engineering. It is designed for 40 Channel Citizen Band ope

5 for important buttons and controls. 1. Place 4 AA batteries (not supplied) into the compartment on the underside of the radio. (Note:batteries are important because they provide emergency power for the radio in case of a power outage.) 2. Plug the AC adapter into a standard house outlet. Plug the other end of the adapter into the DC jack on the back of the radio. 3. Pull out the antenna and extend to its full length above the weather radio 4. Program the Weather Channel for Your Area( A). Turn

In this book… IN THIS BOOK…................................................................................................................................................. 2 WARNING NOTES ................................................................................................................................................. 3 FCC LICENSING INFORMATION............................................................................................................................ 3 SAFETY ....

The LED indicator will glow red indicating the battery is charging. 5. The rapid charger will fully charge the 1300 mAH NiMH battery in approximately 1.5 hours. The rapid charger will change to a green LED and switch to a trickle charge rate when a full charge is detected. The standard rate charger will charge at a constant rate (requires about 12 hours to fully charge a dead battery) and batteries should not be left in the charger longer than 15 hours. The LED of the standard rate charger does

Full discharge will be indecated by the ‘8ATTA.OW indicator. • The above will prevent the batteries from developing •memory' which effectively reduces their capacity. • It is better to store Ni-Cd batteries that are discharged rather than charged. • Never use batteries which differ from the ones recommended. Do not mix old and new batteries or batteries of different capacities. • If you experience problems when using the transceiver, check the following: A. Batteries must be in good conditi

If you press the upper function button for less than two seconds the monitor mode will be activated while pressed and deactivated when released. For details, please see the “Monitoring the channel” section. .. If you press the upper function button for more than two seconds the monitor mode will latch on. To turn the monitor mode off, press and release the upper function button. For details, please see the “Monitoring the channel” section. [8] PTT (Push to talk) button. The PTT button must be pr

.. If the status LED blinks red once every five seconds in standby, the battery needs charging. When a low battery condition is detected, the radio will automatically revert to low power when transmitting to help prolong the battery's life. If beeps are enabled, two short beeps will be heard before each transmission indicating the radio has automatically switched to low power mode. Sending a 2-tone/selective call or emergency call Your radio may have been programmed to send a 2-tone or selective

2 Thank you................................................................................................................................................................................ 2 HH54 Features, Controls and LCD Indicators .............................................................................................................. 3 Set the Clock.............................................................................................................................................

From its high tech detachable control panel to finned cast almuinum transmitter heatsink it incorporates features found on no other CB. These features include full surface mount technoloy, fiberglass printed circuit board, dual power output stage, and a digital information screen using a black matrix LCD (liquid crystal display). All the features are under microprocessor control for increased function and reliability. Your Midland 79-290 assures you of having the ultimate technology in a CB radi