8 6 5 598111-01,PW1300 manual 1/31/05 1:51 PM Page 6 YOUR PRESSURE WASHER IS NOW READY TO USE - PLEASE REVIEW THE FOLLOWING FOR DETAILS ON ACCESSORIES APPLICATION. ACCESSORIES CAUTION: Before changing accessories, turn unit off, pull trigger to release pressure, and activate safety catch. • ADJUSTABLE FAN WAND 1.) Insert the fan wand (D) into the gun wand (E) by pushing and rotating until the two parts are locked as shown in Figure A. A 2.) To obtain maximum pressure, rotate the fan wand nozzle

SAVE THIS MANUAL FOR FUTURE REFERENCE. VEA EL ESPANOL EN LA CONTRAPORTADA. INSTRUCTIVO DE OPERACION, CENTROS DE SERVICIOY POLIZA DE GARANTIA. ADVERTENCIA: LEASE ESTE INSTRUCTIVO ANTES DE USAR EL PRODUCTO. 598121-00 Pressure Wash Revised 11/24/03 2:00 PM Page 2 IMPORTANT SAFETY INSTRUCTIONS WARNING: When using this product, basic precautions should always be followed, including the following: 1. Read and understand all instructions before using the product. 2. To reduce the risk of injury, close

The plug must be plugged into an appropriate outlet that is properly installed and grounded in accordance with all local codes and ordinances. DANGER: Improper connection of the equipment-grounding conductor can result in a risk of electrocution. Check with a qualified electrician or service personnel if you are in doubt as to whether the outlet is properly grounded. Do not modify the plug provided with the product - if it will not fit the outlet, have a proper outlet installed by a qualified el

The appliance should only be connected to a mains power supply equipped with an adequate earth connection and a d erential security breaker (30 mA) to cut the electricity supply in the instance of a short circuit. 5.3.1 Use of extension cables Use cables featuring “IPX5” protection level. The cross-section of the extension cable should be proportionate to its length; the longer it is, the greater its cross-section should be. See table I. 5.4 Water supply connection Caution -Danger! Only clean or

If the supply cord is damaged, it must be replaced by themanufacturer, an authorized Black & Decker Service Centre or an equally qualied person in order to avoid ahazard. If the supply cord is replaced by an equally qualied person, but not authorized by Black & Decker, the warranty will lose eect. ACCIDENT HAZARD DISCHARGE residual pressure before disconnecting the unit hose. INJURY HAZARD 2.2.8 Before using the appliance, CHECK every time that the screws are fully tightened and that there are n

2.2.12 rEAd iNSTruCTioN mANuAL BEForE uSE 15 ENGLISH 3 GENERAL INFORMATION (FIG.1) 3.1 Use of the manual This manual forms an integral part of the appliance and should be kept for future reference. Please read it carefully before installing/ using the unit. if the appliance is sold, the Seller must pass on this manual to the new owner along with the appliance. 3.2 Delivery The appliance is delivered partially assembled in a cardboard box. The supply package is illustrated in Fig.1. 3.2.1 Documen

IFYOU HAVEASUGGESTION OR COMMENT, GIVE USACALL.YOUR FEEDBACK IS VITALTO BLACK & DECKER. SAVE THIS MANUAL FOR FUTURE REFERENCE. VEA EL ESPANOL EN LA CONTRAPORTADA. INSTRUCTIVO DE OPERACION, CENTROS DE SERVICIOY POLIZA DE GARANTIA. ADVERTENCIA: LEASE ESTE INSTRUCTIVO ANTES DE USAR EL PRODUCTO. 598111-01,PW1300 manual 1/31/05 1:51 PM Page 2 IMPORTANT SAFETY INSTRUCTIONS WARNING: When using this product, basic precautions should always be followed, including the following: 1. Read and understand all

1) Turn on the water supply tap fully. 2) Release the safety catch (D). 3) Depress the gun trigger for a few seconds and start up the appli ance using the starter device (ON/1). AS models -In AS models with automatic delivery ow cut-o system: -When the gun trigger is released the dynamic pressure automati cally cuts out the motor (see g.4); -When the gun trigger is depressed the automatic drop in pressure starts the motor and the pressure is restored after a very slight delay; -If the AS is to f

V..............volts A..............amperes Hz............hertz W ............watts min ..........minutes ............alternating current ........direct current no ............no load speed ............Class II Construction …/min......revolutions or reciprocation per minute ............earthing terminal ............safety alert symbol SAVE THESE INSTRUCTIONS 3 4 A. Water outlet (OUTLET) B/B1 Water inlet with filter (INLET) C. High pressure turbo wand D. Adjustable fan wand E. Wheels F. Revolving

To prevent damage to the appliance, when running do not stop the water jet for more than 10 minutes at a time. 7.3 Stopping the appliance 1) Set the starter device switch on (OFF/0). 2) Depress the gun trigger and discharge the residual pressure inside the hoses. 3) Engage the gun safety catch (D). English 19 7.4 Restarting 1) Release the safety catch (D). 2) Depress the gun trigger and discharge the residual air inside the hoses. 3) Set the starter device on (ON/1). 7.5 Storage 1) Switch the ap