Оценок - 0, средний балл: 0
(
)
)
|
К этому устройству также есть другие инструкции:
Фрагмент инструкции
Introduction
User Defined Messages
User Defined Messages
Two statements permit you to create your own messages in ALLBASE/SQL procedures
and applications:
• RAISE ERROR
• PRINT
RAISE ERROR
The RAISE ERROR statement permits users to define their own message catalogs. The
number range 7000 - 7999 is reserved for use in RAISE ERROR. No errors in this range
will be generated by ALLBASE/SQL.
Each error caused by the RAISE ERROR statement is a regular error that generates a
message placed in the message buffer. A raised error halts the execution of a rule, if issued
within a procedure invoked by a rule. A raised error does not cause transaction rollback or
disconnection from the DBEnvironment.
Any use of this statement will generate an error. The error number returned in SQLCODE
will be the specified error number or, if none is specified, the default error number (2350).
The error text returned will be the error text specified. If no text is specified, then no text is
returned. Messages stored in the message buffer are available to application programs
through the use of the SQLEXPLAIN statement. Inside application programs, test
SQLCODE, and if its value is less than zero, use SQLEXPLAIN to retrieve messages
stored in the message buffer. SQLEXPLAIN cannot be used inside procedures.
The RAISE ERROR statement can be used to override the existing message catalog if the
user issues this statement with an existing error number defined in this manual. However,
if existing warning numbers are used, raised errors are not treated as warnings; they are
always treated as errors.
You should define the action a user should take for each error number used with RAISE
ERROR. You can do this by including an explanation in the error text itself or in external
documentation. Refer to the ALLBASE/SQL Reference Manual for additional information
on using the RAISE ERROR statement.
PRINT
The PRINT statement, available only inside procedures, lets you place informational
messages in the message buffer. PRINT is intended for informational messages that have
the status of warnings (though no actual warning may be intended). No numbers are
assigned in the PRINT statement. Inside application programs, test SQLWARN0 for a
value of 'W', and if this condition is true, use SQLEXPLAIN to retrieve messages stored in
the message buffer. Refer to the ALLBASE/SQL Reference Manual for additional
information on using the PRINT statement.
10
Chapter 1
...Эта инструкция также подходит к моделям:
Программное обеспечение - MPE/iX 6.5 Operating System (1.01 mb)
Программное обеспечение - MPE/iX 7.0 Operating System (1.01 mb)
Программное обеспечение - MPE/iX 7.5 Operating System (1.01 mb)