Оценок - 0, средний балл: 0
(
)
)
|
К этому устройству также есть другие инструкции:
Фрагмент инструкции
NOTE: To allow this system to be used as an InfoServer just while installing OpenVMS on a Server Blade,
you can use the following commands to accomplish the equivalent of steps 1 to 6 in Section C.3, including
limiting the InfoServer to a single network device. Substitute the appropriate device for “EWA” in these
commands.
$ COPY SYS$STARTUP:ESS$LAD_STARTUP.TEMPLATE -
_$ SYS$STARTUP:ESS$LAD_STARTUP.DAT
$ COPY SYS$STARTUP:ESS$LAST_STARTUP.TEMPLATE –
_$ SYS$STARTUP:ESS$LAST_STARTUP.DAT
$ DEFINE/SYSTEM/EXECUTIVE_MODE LAST$DEVICE EWA
$ @SYS$STARTUP:ESS$LAD_STARTUP
When you get to step 7 in Section C.3 of the OpenVMS Upgrade and Installation Manual, use
the following commands to create a service (I64083B) for the spare disk (DKB0:):
$ MOUNT/SYSTEM/NOWRITE DKB0: I64083B
$ INFOSERVER :== $ESS$INFOSERVER
$ INFOSERVER
INFOSERVER> CREATE SERVICE I64083B DKB0:
INFOSERVER> EXIT
5. Set up the OpenVMS BOOTP and TFTP servers as instructed in Section C.4 of the OpenVMS Upgrade and
Installation Manual.
NOTE:
Verify that the BOOTP and TFTP servers are configured and started by using the HP TCP/IP
Services for OpenVMS SYS$MANAGER:TCPIP$CONFIG.COM configuration procedure. From
the Main Configuration menu, select option 3 (“Server components”). If a BOOTP or TFTP service
is not enabled and started, select the appropriate server option and then enable and start the service
accordingly. For more information, see the HP TCP/IP Services for OpenVMS documentation
available at the following Web site:
http://h71000.www7.hp.com/doc/tcpip56.html
The VMS_LOADER.EXE and IPB.EXE files are located in [SYS0.SYSCOMMON.SYSEXE], not
[SYSEXE]; they must be copied from the patched copy of the DVD on the spare disk of your boot
server (step 3 and Example C-1 of the OpenVMS Upgrade and Installation Manual). Using our
example, the COPY commands in Example C-1 would be:
$ COPY DKB0:[SYS0.SYSCOMMON.SYSEXE]VMS_LOADER.EFI TCPIP$TFTP_ROOT:[V83]*
$ COPY DKB0:[SYS0.SYSCOMMON.SYSEXE]IPB.EXE TCPIP$TFTP_ROOT:[V83]*
The file name in the /FILE qualifier of the TCPIP SET BOOTP command is
[V83]VMS_LOADER.EFI (step 6 and Example C-1).
Do not include the /FULL qualifier with the TCPIP SHOW HOST command (Example C-1).
Display the BOOTP server information with the TCPIP SHOW BOOTP /FULL command (Example
C-1).
HP Part No. 5992-0787
5
June 2007
...Эта инструкция также подходит к моделям:
Компьютеры - HP BL860c Single Processor Server Blade (63.79 kb)
Компьютеры - HP Integrity BL860c Carrier-grade Server Blade (63.79 kb)
Компьютеры - HP Integrity BL860c Server Blade (63.79 kb)