Оценок - 0, средний балл: 0
(
)
)
|
К этому устройству также есть другие инструкции:
Фрагмент инструкции
2.
For systems running Windows Server 2008 SP2 (or earlier):
a.
At the EFI menu, select Windows and press Enter.
NOTE:
In rx2660 systems where EFI “Fast Initialization” has been enabled, a Smart
Array message displays, asking you to press the F8 or Escape key. Please wait for this
message to go away before proceeding to the next step.
b.
Immediately press F8 (you must be very fast). If the system boots to Windows instead,
it means you were not fast enough, and you must reboot the system and start over.
For systems running Windows Server 2008 R2:
a) At the EFI menu, select Windows and press Enter.
b) Press the Space bar.
c) Press F8 when prompted.
3.
Use the arrow keys to select Safe Mode, and then press Enter.
4.
If you are running other operating systems on the server, select Microsoft Windows Server
2008 from the list, and then press Enter.
If the server does not start in Safe mode, try looking for possible hardware problems, such as
defective devices, installation problems, cabling problems, or connector problems. Remove any
newly added hardware, and then restart the server.
If the server does start in Safe mode, use the following tools to troubleshoot the problem:
•
Event Viewer: The event logs in Event Viewer can help identify and diagnose the cause of
the startup problem. To start the Event Viewer, click Start > Administrative Tools > Event
Viewer. In the Event Viewer, click the System log or the Application log to view the events
recorded in the logs.
•
System Information: The System Information tool displays a comprehensive view of the
computer's hardware, system components, and software environment. Use this tool to help
identify possible problem devices and device conflicts. To run System Information and look
for problem devices or device conflicts, click Start > Run, type msinfo32, and then click
OK.
•
Safe Mode Boot Log File: This log file is located in the %SystemRoot% folder (by default,
this is the Windows folder). The log file lists devices and services that load (and do not load)
when you start the computer in Safe mode. Use a text editor to open and view the log file.
Then use the list of drivers and services that did not load at startup to help identify the
possible cause of the startup problem.
•
Device Manager: Device Manager displays a graphical view of the hardware installed on
your computer. Use this tool to resolve any possible device conflicts or to identify
incompatible devices that might be the cause of the startup problem. To start Device Manager,
click Start > Control Panel, then click System > Device Manager.
NOTE:
Since a Safe Mode boot only supports one processor, any additional system
processors are shown with a yellow bang (!) symbol in the Device Manager. This is normal
and these yellow bangs can be safely ignored.
If you identify a problem device, driver, or service, disable the device, uninstall the driver, or
stop the service, and then restart the server in normal mode. Contact the component manufacturer
for support.
ResQme
ResQme is an advanced support tool designed by HP support to troubleshoot system problems
when all other recovery options fail. ResQme enables HP Support to gather critical information
even if the system is down and cannot be booted.
ResQme
11
...Эта инструкция также подходит к моделям:
Компьютеры - HP BL860c Single Processor Server Blade (272.92 kb)
Компьютеры - HP Integrity BL860c Carrier-grade Server Blade (272.92 kb)
Компьютеры - HP Integrity BL860c i2 Server Blade (272.92 kb)
Компьютеры - HP Integrity BL860c Server Blade (272.92 kb)