Besides the data sheet, circuit requirements, certain setup and operation procedures, the wiring diagram, and parts in this insert, the content in the Model G0513X owner's manual is the same for both machines. On the following pages, the header indicates which page it replaces in the Model G0513X manual, if applicable. Before operating your new machine, you MUST read and understand this insert and the entire Model G0513X manual to reduce the risk of injury from improper use or setup. If you ha

Remedy the metal to metal contact problem before resuming operation. 7. OPERATIONAL QUESTIONS. If at any time you are experiencing difficulties performing the intended operation, stop using the machine! Then contact our Tech Support or ask a qualified expert how the operation should be performed. 8. CLEANING AIR. Do not confuse this dust collector with an air cleaner. This dust collector is only designed to collect dust from a machine, not clean dust suspended in the air. 9. EMPTYING DUST. Wh

ft. Each Impeller Information Type.........................................................................................................................................................................Curve Size............................................................................................................................................................................141/2" Blade Thickness.........................................................................................

Occasionally we pre-install certain components for shipping purposes. Contents (Figures 7 & 8) Qty A. Collectors ................................................... 2 B. impeller Housing with Motor.......................1 C. Casters.......................................................4 D. Leg Braces.................................................4 E. Legs............................................................ 4 F. Gaskets ...................................................... 2 G

Fully tighten the bolts and the hardware from Step 2. G0671/G0672/G0673 Dust Collector -21- 4. Attach the four casters to the legs by threading them into the bottom of the legs, as shown in Figure 15. Figure 15. Attaching casters. 5. With assistance, turn the entire assembly over so that the casters rest on the floor. 6. Use eight 5/16"-18 x 1" hex bolts, (16) 5/16" flat washers, and eight 5/16"-18 hex nuts to attach each collector to the impeller housing with a rubber gasket between the c

#JB11086 printEd in China ..........................................................................................................................................................................................................................................................................................................................................................................................................................................................................................

To reduce your exposure to these chemicals: Work in a well ventilated area, and work with approved safety equipment, such as those dust masks that are specially designed to filter out microscopic particles. Table of Contents INTRODUCTION...............................................2 Foreword........................................................2 Contact info....................................................2 Functional Overview......................................2 identification...

6. Rework the ducting to eliminate all leaks. Close dust ports for lines not being used. 7. Open 1 or 2 more blast gates to different branch lines to allow the velocity in the main line to increase. 8. Reinstall correctly sized ducts and fittings. Refer to System Design beginning on Page 19 for more solutions. 9. Use a dust collection nozzle on a stand. 10. Install a larger dust collector to power your dust collection system. Sawdust being blown into the air from the dust collector. 1. Duct cla

#CR9072 PRINTED IN CHINA ...........................................................................................................................................................................................................................................................................................................................................................................................................................................................................................