Do not use in the bathroom or near any source of water. Do not use outdoors. • Do not touch hot surfaces i.e. body or lid. Use handles or knobs. • Do not remove the lid while the kettle is boiling. • Take care when pouring - do not over-tilt the kettle as water may enter into the switch mechanism. • Water can remain hot for a long time after boiling, and can present a scald hazard. Keep the kettle and the mains lead away from the edge of the work surface and out of the reach of children. • Do no

The flexible mains lead is supplied connected to a B.S. 1363 fused plug having a fuse of 13 amp capacity.Should this plug not fit the socket outlets in your home, it should be cut off and replaced with a suitable plug, following the procedure outlined below. Note: Such a plug cannot be used for any other appliance and should therefore be properly disposed of, (having removed the fuse) and not left where children might find it and plug it into a supply socket - with the obvious consequent danger.

This is the only way to ensure optimum results and maximum safety. Before use • Check that the appliance has not been damaged during transport. • Remove all packaging from the kettle and power base. • Remove any labels from the outer surfaces. • Remove the filter (fig. 1) and wash with water (fig. 2). Refer to page 5.“Removing the scale filter” • Fill the kettle and boil. • The boiled water should be discarded and the kettle rinsed out with cold water.This procedure should be carried out three t

or 2 oz. of citric acid cristal and then fill with water up to the max level indicated and then boil. Allow the contents to cool, and then rinse thoroughly. • Do not use a more concentrated solution. If the filter requires descaling, remove the filter and place into the citric acid solution. • Ensure that the electrical connections are completely dry before using the kettle. • Citric acid crystals are available from most pharmacies. Safety Warnings Please read these instructions before operating

• Remove the kettle from its power base before filling. •Never move the kettle while it is in use. • Do not use the kettle if you have wet hands. •Keep the kettle, the power base, and the mains lead away from hotplates, hobs or burners. 6 Kettle • Do not use the kettle for any purpose other than heating water. •Do not place any utensils into the kettle. • Do not operate on an inclined surface. •Do not operate unless the element is fully immersed. • The use of accessory attachments not recommende

This is the only way to ensure optimum results and maximum safety. Using for the first time • Before use, check that the appliance has not been damaged during transport. • Remove all packaging from the kettle and power base. • Remove any labels from the outer surfaces. • Remove the filter by pushing as shown in fig. 1 and wash with water (fig. 2). Refer to page 5.“Removing the scale filter” • Fill the kettle and boil. • The boiled water should be discarded and the kettle rinsed out with cold wat

You should remove and clean the water filter when you notice any deposits being left on the filter or if the pouring efficiency is impaired. Removing the scale filter • Allow the kettle to cool down fully. • Disconnect the appliance from the mains electrical supply. • Make sure that your hands are clean and free from soap, cream or anything which might taint the water. • Empty the kettle and open the lid. Remove the filter by pushing firmly the catch from inside the kettle, then lift up. • Rinse

•After the kettle has been rinsed out, refit the filter (fig. 3). Using the kettle With the specially designed power base and central connector, you can now set the kettle on the base at any angle, from any position. • Release cord from storage base and adjust length by winding around the base to give the correct cord length to reach the plug socket to be used (fig. 4). • Do not leave loose cord hanging over the edge of work surfaces. Filling • Remove the kettle from the base unit before filling

As soon as you notice a film forming on the water, or, when cleaning the filter, if you notice a film on the walls or the element, simply rinse the kettle and wipe it out. Scale filter Your kettle is fitted with a scale filter to prevent loose particles of scale being poured into your beverage.This filter is both removable and washable. The frequency with which you will need to clean any scale deposits from your filter will depend on the hardness of water in your area and how often you use the k

Let the kettle cool down before refilling. When it has cooled down, the kettle will reset itself. -6 TROUBLESHOOTING 1. If you experience difficulties with your kettle switching on and off during use or switching off before boiling, check that the interior of the kettle is free from lime scale build-up. (See “Cleaning your Kettle” section for more details about decalcification.) 2. If you see drops of water under your kettle this is just condensation. WATER FILTER 1. Your kettle is equipped with