All wiring must comply with local and national electrical codes and must be installed by a licenced electrician. If you have any questions regarding the following instructions, contact a licenced electrician. 2. Check available power supply and resolve any wiring problems BEFORE installing and operating this unit. 3. For your safety and protection, this unit is grounded through the power cord when plugged into a matching wall outlet. If you are not sure whether your wall outlet is properly groun

When the air conditioner is heating, allow 3 minutes after you press this button. NOTE: After setting the mode, allow 3 minutes before switching to another mode. In the FAN ONLY Mode, Room Temperature display range is from 0 (32 ) to 38 (99 ). Room Temperature below 32 ,the Temperature display L0. Room Temperature above 99 ,the Temperature display H1. Operating Instructions Remote control 1 2 3 4 7 Power Mode +_ Temp/Time Auto Power Saver Mid High Low Timer Fan Speed 1 2 3 8 5 6 84 5 6 7 9 9 Pow

THIS WARRANTY DOES NOT COVER LIABILITY FOR INCIDENTAL OR CONSEQUENTIAL DAMAGES FOR ANY CAUSE WHATSOEVER. This warranty is extended to the original owner and any succeeding owner for products purchased for home use within the USA. Some states do not allow the exclusion or limitation of incidental or consequential damages. This warranty gives you specific rights, and you may also have other rights which may vary from state to state. To know what your legal rights are, consult your local or state c

If the leveling screws are distanced too far away from the wall to provide stability, it may be necessary for you to fill this area with a solid piece of wood. See (Fig. 8). Fig. 5 Bracket Assembly Bracket Bolts Leveling Screw V-slot 90 Angle Support Brackets (TOP VIEW) Center Window sill V-slot (2) 3/4" screws per bracket Bracket Assembly Leveling Screw Outer Wall Construction 3/16" Maximum B. Measure the inside window sill width and find the center as shown in (Fig. 6). Align the V-slot in eac

See (Fig. 2). NOTE: Screws must be reinstalled upon completion of the window installation to secure slide-out chassis. Please seek assistance for this procedure. Fig. 2 Fig. 1 Right side Philips screws Shutter Frame Right Shutter 1/4" screw For 10K to 12K models Channel 1/4" Screw Fig. 3 Fig. 4 Installation instructions 3. Assembly of the upper & lower channels to the cabinet A. " L" Shaped Top Channel: Stick the double adhering seal to the " L" shaped top channel, and then Install the "L" shape

Check with dealer to determine proper unit capacity for application. Remove obstruction from grill or outdoor louvers. Let fan run to restart compressor (in approximately 10 minutes). Noisy unit Loose parts. Inadequate support. Tighten loose parts. Provide additional support to unit. Odors Formation of mold, mildew, or algae on wet surfaces. drain plug and drain base pan. Replace drain plug. Clean unit thoroughly. Remove Water dripping outside Condensation run-off is normal during hot and humid

Pull the window down until it rests just behind the front of the "L" shaped mounting channel. See (Fig. 11). A. Align one hole in the bottom of the cabinet with one hole in the bracket assembly. Secure the cabinet to the bracket using (3) 1/4" screws provided. Repeat the same procedure on the opposite side of the cabinet. See (Fig. 10). C. Check to make sure that the cabinet is slanted slightly downward on the outside. If necessary, re-adjust support bracket as shown in (Fig. 7). Fig. 10 1/4" Sc

More frequent cleaning may be necessary depending on outdoor and indoor air quality. 3. Use drapes, curtains, or shades to keep direct sunlight from heating your room, but DO NOT obstruct the air conditioner. Allow air to circulate around the unit without obstructions. 4. Start your air conditioner before outdoor air becomes hot/cold and uncomfortable. This avoids an initial period of discomfort while the unit is cooling or heating off the room. 5. When outdoor temperature is cool enough, use HI

Use and Care Manual Manual de Uso y Mantenimiento Remote control Mechanical control Fan Speed Mode Timer Airconditioner AAW-12DR3FHU AAW-12CR1FHU AAW-10DR3FHU AAW-10CR1FHU AAW-24DR3FHU AAW-24CR3FHU AAW-18DR3FHU AAW-18CR3FHU AAW-24CM3FHU AAW-18CM3FHU AAW-12CM1FHU AAW-10CM1FHU Admiral Admiral LOW FAN MED FAN HIGH FAN OFF HIGH COOL MED COOL LOW COOL 1 3 5 7 9 CO LER O1 For services, call 1 877 465 3566 Muchas gracias por comprar un Aire Acondicionado . Lea atentamente el Manual de Uso y Mantenimien

Recommended for nighttime use. MED COOL provides cooling, automatically with middle air circulation. Recommended for nighttime use. HIGH COOL provides cooling, automatically with quick cooling or for extremely hot days. Once room is cooled, reduce setting to LOW COOL. NOTE: After setting the mode, allow 3 minutes before switching to another mode. OFF will completely shut-off the unit. THERMOSTAT The thermostat automatically controls the cooling cycle (compressor) of the air conditioner to mainta