Оценок - 1, средний балл: 4 ( )

Производитель: Admiral Размер: 5.71 mb Название файла: Язык инструкции:

Pull the window down until it rests just behind the front of the "L" shaped mounting channel. See (Fig. 11). A. Align one hole in the bottom of the cabinet with one hole in the bracket assembly. Secure the cabinet to the bracket using (3) 1/4" screws provided. Repeat the same procedure on the opposite side of the cabinet. See (Fig. 10). C. Check to make sure that the cabinet is slanted slightly downward on the outside. If necessary, re-adjust support bracket as shown in (Fig. 7). Fig. 10 1/4" Screws Fig. 11 7. Secure Shutters A. Carefully slide the air conditioner back into the cabinet.(Please seek assistance for this procedure). B. Reinstall the slide-out-chassis security screws (removed earlier) on both sides of the cabinet. See (Fig. 12). Secure the top of the frames to the window sash with (2) 3/4" screws. C. Now, secure bottom frame of shutters using one shutter clamp and one 3/4" screw on each side(Fig. 12). 8. Reinstalling Front Panel Assembly A. Position the front panel on the cabinet starting at the top. The front panel lock tabs must be inserted into the retaining slots in the cabinet. Repeat this procedure on all sides. B. Secure the front grille to the cabinet using the Philips screws removed earlier(Fig. 1). Fig. 12 Installation instructions Window Sash "L"Shaped Mounting Channel Seal Coil 3/4" screws Security Screw "L"Shaped Mounting Channel Seal F HR FAN SPEED MODE OFFON/ TIMER Airconditioner WAIT THREE MINUTES BEFORE RESTARTING 9. Complete the installation B. Some installations may require additional sealing around the window and air conditioner. Check for any air leaks and seal where necessary. C. In very humid areas, the water removal may be excessive enough to overflow the unit or increase the noise of the air conditioner. If this occurs, you may wish to attach a drain hose (not included) to the drain plug allowing condensations to run off conveniently. See (Fig. 14). Fig. 14 Drain Hose (not included) Fig. 13 Installation instructions 10 A. Cut the foam to fit the opening between the top of the inside and outside window. See (Fig. 13). Foam 9. Complete the installation B. Some installations may require additional sealing around the window and air conditioner. Check for any air leaks and seal where necessary. C. In very humid areas, the water removal may be excessive enough to overflow the unit or increase the noise of the air conditioner. If this occurs, you may wish to attach a drain hose (not included) to the drain plug allowing condensations to run off conveniently. See (Fig. 14). Fig. 14 Drain Hose (not included) Fig. 13 Installation instructions 10 A. Cut the foam to fit the opening between the top of the inside and outside window. See (Fig. 13). Foam 11 When using FAN control, turn slowly allowing unit to adjust. When using THERMOSTAT, be sure to allow three minutes before changing temperature. Adjusting too quickly may cause an overload resulting in a blown fuse. ! CAUTION ! MODE The mode knob controls fan speeds and coo...

Скачать инструкцию

Чтобы скачать, введите 2 цифры: