Оценок - 0, средний балл: 5
(
)
)
|
Фрагмент инструкции
More frequent cleaning may be necessary depending on outdoor and indoor air quality. 3. Use drapes, curtains, or shades to keep direct sunlight from heating your room, but DO NOT obstruct the air conditioner. Allow air to circulate around the unit without obstructions. 4. Start your air conditioner before outdoor air becomes hot/cold and uncomfortable. This avoids an initial period of discomfort while the unit is cooling or heating off the room. 5. When outdoor temperature is cool enough, use HIGH or LOW FAN only. This circulates indoor air, providing some cooling comfort, and utilizes less electricity than when operating on a cooling setting. To avoid installation/operating difficulties, read the instructions thoroughly. NOTE: Save the shipping carton and packing materials for future storage or transport of the unit. Please check the contents of the hardware kit against the corresponding model check list, prior to installation of the unit. See lists below.(Fig.A) CAUTION! ! Your Room Air Conditioner was designed for easy installation in a single or double-hung window. NOTE: This unit is NOT designed for vertical (slider type) windows. Tools Needed for Window Installation Screw drivers: Both Philips and flat head Power drill: 1/8 inch diameter drill bit Pencil Measuring tape Scissors Carpenters level 3/4"Screws (10) Top Channel(1) End Cap & Leveling Legs(2) Bottom Channel(1) (For 10K to 12K models) Lock Washers(4) 1/4" Nuts(4) MountingBrackets(2) AngleBrackets(2) 1-1/2"x1/4 Bolts(4) Side Curtain RH(1) Side Curtain LH(1) Shutter Clamp(2)3/4"Screws (10) 1/4"Screws (23) Top Channel(1) Seal(1) Lock Washers(4) 1/4" Nuts(4) Mounting Brackets(2) Angle Brackets(2) 1-1/2"x1/4 Bolts(4) Side Curtain RH(1) Side Curtain LH(1) Shutter Clamp(2) Fig. A Installation Hardware Washer(10) NOTE: Surplus screw(s) for spare use. Foam (1) Double Adhering Seal(1) Bottom Channel(1) (For 18K to 24K models -Factory Installed) Installation instructions Awning Side obstruction Ground Fence, wall, or other obstacle. 12" Min. 30" Min. 20" Min. 20" Min. E. Be certain the proper electrical outlet is within reach of the installation. Use only a single outlet circuit rated at proper current (see table 1 on page 4). All wiring should be in accordance with local and national electrical codes. F. Your unit was designed to evaporate condensation under normal conditions. However, under extreme humidity conditions, excess condensation may cause the basepan to overflow to the outside. The unit should be installed where condensation run-off cannot drip on pedestrians or neighboring properties. CAUTION! ! Because the compressor is located on the controls side of the unit (right side), this side will be heavier and more awkward to manipulate. Inadequate support on control side of the unit can result in personal injury and damage to your unit and property. Therefore, it is recommended to have someone assist you during the installation of this unit. 1. Select the Best Location A. Your room air...
Эта инструкция также подходит к моделям:Кондиционеры - AAW-10CM1FHU (5.71 mb)
Кондиционеры - AAW-10CM1FHU (5.71 mb)
Кондиционеры - AAW-10CR1FHU (5.71 mb)
Кондиционеры - AAW-10DR3FHU (5.71 mb)