2. Ember Control Dial: There is a divided circle under this dial. After you turn the Main Power switch to the ON position, turn the Ember Control Dial to desired setting. This dial controls the intensity of the lighting under the ember bed. 3. Flame Control Dial: There is a flame picture under this dial. Turn this dial to adjust the flame intensity. 4. Heater Switch and Control Dial: The heater switch has a sun directly below it. To turn the heater on, flip Heater Switch to ON position ( "|" ind

• 1 bulb provides illumination for the ember bed beneath the log set • 2 bulbs provide illumination for the flame generation assembly • 2 bulbs for replacement Most halogen light bulbs are rated to last approximately 1800 hours. Like all light bulbs, halogen bulbs require periodic replacement. When the bulbs in your unit have burned out you will notice one or more of the following: • Flame is dim or dark in certain areas • Log set ember bed appears dim or dark in certain areas WARNING: Do not in

Prior to permanently installing the unit, test to make sure the unit operates properly by plugging the power supply cord into a conveniently located 120-volt grounded outlet. CAUTION: The unit's power supply cord must be connected to a properly grounded and pro- tected 120-volt outlet. Always use ground fault protection where required by the electri- cal code. WARNING: Do not operate the unit if it is damaged or has malfunctioned.Ifyoususpectthe unit is damaged, return the unit to an authorized

To increase the brightness, press and release the BRIGHTER button. Each time you press this button you will hear a beep, and the brightness will increase by a small amount, until the maximum is reached. To decrease the brightness, press and release the DIMMER button. Each time you press this button you will hear a beep and the brightness will decrease by a small amount, until the minimum brightness is reached. Infrared Ray Exit FLAME TEMP. CONTROL POWER ON/OFF ON/OFF ON/OFF HIGH MED LOW LOWER HE

Carefully remove mirror from unit by lifting it gently from the stove. Store in a safe place or lay it face down on the carpet. 2. From the bottom, lift up the log set ember bed and remove it from the unit (do not pull up on logs). 3. Remove spring clip from bulb. Hold socket and pull out old bulb. 4. Hold socket and push in new bulb. Replace spring clip. 5. Repeat steps 2 and 3 for the second bulb. Figure 7 - Ember Bed Bulb Replacement (Looking in from Top of Unit) Log Grate Bulb with Spring Cl

Failure to follow them could cause a heater malfunction resulting in serious injury and/or property damage. Save this manual for future reference. For more information, visit TABLE OF CONTENTS Safety Information ............................................... 2 Listing Approvals ................................................. 3 Unpacking and Testing the Unit........................... 3 Product DimensionS & Specifications ................. 3 Grounding Instructions .............................

The heater has a built-in thermostat so it will shut off automatically once the settemperature is reached. It will also turn on automatically if the room temperature drops below the set temperature on the dial. Note: When the heater is turned on for the first time, it may release a slight, harmless odor.Thisodoris a normal occurrence caused by the initial heating of the internal heating Figure 2 - Grounding Methods Figure 3 - Electric Stove Control Panel OPERATING INSTRUCTIONS Once the unit has

Note: Do not exert excessive pressure on the drum cylinder as this may cause damage. 5. Remove spring clip. Hold socket and pull out old bulb. 6. Hold socket and push in new bulb. Replace spring clip. 7. Insert bottom edge of removed cylinder half into bottom of drum track. Gently squeeze drum cylinder until it's top edge fits into top drum rack. Flame Generation Bulb Ember Bed Bulb Cylinder Figure 5 - Cylinder and Bulb Locations Replacing Ember Bed Bulbs 1. Unplug unit from the power supply. 2.