Оценок - 2, средний балл: 3.5
(
)
)
|
Фрагмент инструкции
To increase the brightness, press and release the BRIGHTER button. Each time you press this button you will hear a beep, and the brightness will increase by a small amount, until the maximum is reached. To decrease the brightness, press and release the DIMMER button. Each time you press this button you will hear a beep and the brightness will decrease by a small amount, until the minimum brightness is reached. Infrared Ray Exit FLAME TEMP. CONTROL POWER ON/OFF ON/OFF ON/OFF HIGH MED LOW LOWER HEATER DISPLAY HIGHER Dimmer Brighter EMBERS/ LOGSET Indicator Light 5. Heater Button: To activate the heater, press the heater button, then press HI, MED or LO. The heater is per-set to the following temperatures: HIGH will shut off when room reaches approximately 86° F (30 C) MED will shut off when room reaches approximately 75° F (24 C) LO will shut off when room reaches approximately 64° F (18 C) 6. To adjust the intensity of the flame, press the two buttons labeled HIGHER and LOWER under FLAME. To increase the flame intensity, press and release the HIGHER button. Each time you press the button you will hear a beep and the size of the flame will increase slightly until the maximum setting is reached. To decrease the flame intensity, press and release the LOWER button. Each time you press this button you will hear a beep and the size of the flame will decrease slightly until the minimum setting is reached. 7. To use the stove as a heater without the flame, press the LOGSET DISPLAY ON/ OFF button to turn the flame off and press the HEATER ON/OFF button to turn the heater on (if the heater was in the OFF position). Press the LOGSET DISPLAY ON/OFF button again to turn the flame back on. Press HEATER ON/OFF button again to turn the heater off. Note: You may have to re-adjust your desired flame setting (see step 6). 8. To turn off the stove, press the POWER ON/ OFF button once. When you hear the beep, the fireplace will be completely off and the flame will disappear. When you restart the fireplace with the remote control, all of the features you had set will remain in effect. NOTICE: This remote control must remain within 8 meters or 26 feet of the fireplace to be effective. IMPORTANT: If the flame does not activate after the POWER ON/OFF button is pressed, press the DISPLAY ON/OFF button to activate the flame. If the flame does not appear, repeat step 4, page 8. Figure 4 - Remote Control For Electric Fireplace 117190-01B CLEANING AND MAINTENANCE WARNING: Always disconnect power and allow the heater to cool before performing any cleaning,maintenanceorrelocation of this heater. Turn controls to OFF and remove plug from outlet or turn off circuit breaker to heater. Turn off heater and circuit breaker to heater before performing any cleaning and/or maintenance. Allow heater to cool completely. BULB REPLACEMENT WARNING: The halogen light bulbs in your unit can become extremely hot. Allow at least 10 minutes between turning off the heater and remov...
Эта инструкция также подходит к моделям:Варочные панели - CGESBMR (460 kb)
Варочные панели - CGESBMR (460 kb)
Варочные панели - CGESBMR (460 kb)
Варочные панели - CGESBMR (460 kb)