Оценок - 3, средний балл: 3.3 ( )

Производитель: Desa Размер: 718.29 kb Название файла: Язык инструкции:

• 1 bulb provides illumination for the ember bed beneath the log set • 2 bulbs provide illumination for the flame generation assembly • 2 bulbs for replacement Most halogen light bulbs are rated to last approximately 1800 hours. Like all light bulbs, halogen bulbs require periodic replacement. When the bulbs in your unit have burned out you will notice one or more of the following: • Flame is dim or dark in certain areas • Log set ember bed appears dim or dark in certain areas WARNING: Do not install replacement bulbs that exceed specified maximum watts. Your unit must be opened from the back in order to replace the flame generation bulbs. To replace the bulb under the ember bed you will open the unit in front. Replacing Log Set Ember Bed Bulb 1. Turn knob and open door of stove. 2. Push in and up on lower front panel. The panel slides into notches on front sides of stove as shown in Figure 5. 3. Remove two screws securing grate. Remove grate. 4. Hold log up away from bulb and carefully remove spring clip over bulb using needle nose pliers. Remove bulb. 5. With log being held up away from socket, insert new bulb and carefully replace spring clip using needle nose pliers. Replacing Flame Generation Bulbs 1. Unscrew 4 screws from louvered back panel (see Figure 6). Remove louvered back panel. Log Lower Front Panel Bulb in Socket with Spring Clip Grate Figure 5 - Ember Bed Bulb Location Back Control Panel Louvered Back Panel Lower Back Panel Figure 6 - Back of Stove 2. Locate flame generation cylindrical drum (see Figure 7). It is constructed of two removable halves; either of which can be removed from the unit. 3. Squeeze half of drum cylinder until it's top edge clears the top drum track (see Figure 8). Remove bottom edge of cylinder drum from bottom drum track. This will give you access to the light bulbs. Note: Do not exert excessive pressure on drum cylinder as this may cause damage. 4. Remove spring clip. Hold socket and pull out old bulb. 5. Hold socket and push in new bulb (DO NOT exceed wattage). Replace spring clip. 6. Repeat steps 3 and 4 for second bulb. 7. Insert bottom edge of removed cylinder half into bottom drum track. Gently squeeze drum cylinder until it's top edge fits into top drum rack. 8. Replace louvered back panel. Replacing Glass 1. Remove top of stove by sliding top toward the back (see Figure 9). Top fits into slots and should slide off easily. 2. Remove four screws securing back control panel (see Figure 10). DO NOT STRESS WIRES. 3. Remove four screws securing heater/blower assembly to stove assembly (see Figure 10). Assembly must be held securely while removing screws. Cleaning and Maintenance Continued Top of Stove Figure 9 - Removing Top of Stove Glass Panel Heater/Blower Assembly Flame Cylinder Drum Figure 7 - Flame Cylinder Drum Location Flame Cylinder Drum Back Control Panel Figure 8 - Flame Generation Cylinder Drum Figure 10 - Removing Glass Panel 4. Slide heater assembly out back of stove and set aside (see Figur...

Скачать инструкцию

Чтобы скачать, введите 2 цифры: