Оценок - 4, средний балл: 3.8 ( )

Производитель: B.C. Rich Размер: 428.44 kb Название файла: Язык инструкции:

6 11 SETTING UP THE SPEEDLOADER TREMOLO BRIDGE BASE PLATE The proper setup of the SpeedLoader Tremolo Bridge looks exactly like a properly setup Original Floyd Rose Tremolo Bridge. By the way, the SpeedLoader Tremolo will retrofit an Original Floyd quite easily. The first thing you'll want to do is check to see if the top surface of the base plate of the bridge is sitting parallel to the top surface of the guitar. If the base plate appears to be tilted forward away from the top surface of the guitar or tilted back closer to the top of the guitar, then an adjustment should be made. Step 1: To level the base plate, first take the spring cover plate off the back of the guitar. Step 2: Inside the spring cavity you should find a tremolo stop. 10 Step 4: Now remove the bullet from the saddle. Step 5: If you are replacing a broken string, when you unlatch the pivoting saddle there will be no tension on the string to pull the pivoting saddle forward, so you'll have to pivot the saddle forward with your finger. You can now remove the bullet on the other end of the string from the nut by simply sliding it out the back of the nut. This is what the safety catch looks like up close. (see above) Step 6: If you try to release a saddle and pull back on the sliding latch and it won't budge, release everything and start over making certain that you don't turn the sliding latch sideways. If the sliding latch turns on its shaft, the safety catch portion of the sliding latch will not line up properly with the safety catch portion of the pivoting saddle and will cause binding. The safety catch is there to prevent the string from accidentally releasing while playing or changing strings. 7 LOADING SPEEDLOADER STRINGS Step 1: To put on the new string simply slide one of the bullets into the nut, then place the other bullet into the appropriate saddle and push down on the back on the saddle until you hear, or feel, a snap. Step 2: This sound is the spring-loaded sliding latch snapping into place. If you don't hear or feel the snap, push the sliding latch toward the saddle until it catches. Making sure the sliding latch is all the way forward to its locked position is important because if it isn't two things will happen: 1) The replaced string will be held sharp, and; 2) the safety catch will not be engaged and the string could suddenly and unexpectedly be released and fly across the room. Step 3: Now that the new string has been properly installed you should seat the new string.To seat the new string press down firmly on the string just in front of the saddle and just in front of the nut. Step 4: Then do a couple of stretching pulls on the string. Step 5: The string is now seated and no more stretching is necessary, just play. In fact if you stretch the string too vigorously you will damage the string. Just play the string in for a bit and re-adjust your tuning with the fine-tuning screw as needed. If the string you're replacing was tuned to your desired pitch, the new st...

Скачать инструкцию

Чтобы скачать, введите 2 цифры: