Войти:
Оценок - 3, средний балл: 4.7 ( )

Инструкция по эксплуатации B.C. Rich, модель Lefties

Производитель: B.C. Rich
Размер: 428.44 kb
Название файла:
Язык инструкции:en
Перейти к скачиванию



Фрагмент инструкции


Step 7: You must now retune the guitar, this time using a Phillips screwdriver to turn the spring claw screws counterclockwise to loosen the spring tension (If you added an extra spring to pull the spring block against the tremolo stop screw you should remove it first.) Step 8: The good news is that you only have to retune one string. Pluck the string you want to tune (Typically the "A" string for this procedure) and then, while watching the tuner, loosen first one claw screw then the other claw screw the same amount. Check the tuning and repeat until the string is in tune.When you get the string you chose in tune the other strings will be in tune.This assumes that all the strings were in tune before you released the tremolo stop. For foreign language translation of this owner's manual, please visit 15 tuning using the range tuner set screw. Remember: do not use the fine tuner screws to tune the guitar at this point. Step 4: A range tuner setscrew is located in the nose of each pivoting saddle. Step 5: Using a 1.5mm Allen wrench and the range tuner setscrew, tune your guitar to any tuning you desire.You can increase the pitch of a given string by turning the setscrew clockwise, and decrease the pitch of the string by turning the setscrew counterclockwise. (Remember not to use the fine tuner screws for this tuning.) Now that you have tuned your guitar to the tuning you want, the bridge should be properly setup, and the fine tuners should be set to the middle of their range. The way your guitar is set up now is what is called a "blocked" setup.This means that the tremolo can be used for dive effects but you can't pull up on the arm for up bends.You can leave your guitar the way it is, or you can disengage the tremolo stop to return the tremolo to what is called a "floating" setup. However, before you return the bridge to a floating condition, you might want to check your intonation. If your intonation needs adjusting, go to the "Setting your intonation" section. 14 When you do need to change batteries you will get better performance and battery life if you use an alkaline battery.The battery compartment is located on the back of the bass just above the control cavity. It can easily be opened by unscrewing the 2 screws with a Phillips head screwdriver. Changing the battery will not affect your warranty. The controls for both the NJ and Innovator series are as follows: (see photo) • #1 is the Master Volume. It controls the output of both pickups. • #2 is the Blend Control. The purpose of the Blend Control is to be able to select pickups (bridge or neck) and also to be able to blend them together. Turning the knob counterclockwise will bring more of the neck pickup into the mix. Turning it clockwise will bring more of the bridge pickup into the mix. Setting the Blend Control knob in the middle (there is a middle detent position) will place each pickup evenly in the mix. • #3 is the Bass Boost/Cut Control. It controls the amount of bass...

Эта инструкция также подходит к моделям:
Музыкальные инструменты - ASM (428.44 kb)
Музыкальные инструменты - Beast NT (428.44 kb)
Музыкальные инструменты - Bich (428.44 kb)
Музыкальные инструменты - Dagger (428.44 kb)

Напишите ваш отзыв об устройстве



Текст отзыва
Ваше имя:
Введите две цифры:
capcha





Категории