Оценок - 3, средний балл: 3.7 ( )

Производитель: B.C. Rich Размер: 428.44 kb Название файла: Язык инструкции:

* If the fretted note on the 12th fret is sharper (higher) than the open note, move the saddle back away from the neck. For an accurate reading, be sure to retune the string to pitch after each adjustment of the saddle. Bronze and Platinum guitars require a Phillips head screwdriver for this adjustment. Models with the Licensed Floyd Rose will need the supplied 2.5mm allen wrench. The quality of strings affects intonation as does string gauge. An adjustment of the intonation will most likely have to be made if the string gauge is changed. Neck Adjustments Each B.C. Rich Guitar is carefully adjusted at the factory, as well as by our Quality Control Department before shipping.The truss rod and string height are set for optimum action and playability with the gauge string supplied. Occasionally an instrument's neck may need adjustment as a result of string tension or climactic changes.The curvature of the neck should be slightly concave. The amount depends on the player’s personal taste. Truss rod adjustment should only be performed by a B.C. Rich Authorized Service Center. Over adjustment can cause permanent damage that will not be cover by the warranty. 5 REMOVING SPEEDLOADER GUITAR STRINGS *For use with SpeedLoader™ bridges only. Please note: SpeedLoader strings are offered in two scale lengths: 25.5inches and 24.75 inches. If you're not sure what scale length your guitar is, consult the guitar manufacturer or the store where you purchased the guitar. Make sure you have purchased the correct scale length strings for your guitar. The string scale length appears in the lower left corner of the string package. To purchase strings go to: or ask for them at your local dealer. Step 1: To replace a string, push down on the back of the saddle of one of the strings. Step 2: Then, pull back on the sliding latch by placing the first finger of your free hand on the black knob protruding out the back of the saddle then placing your thumb on the fin sticking up just behind the fine tuner screw and pull the latch back with a pinching action between the thumb and first finger. Step 3: Once you have pulled back on the sliding latch, release the saddle and allow it to rotate forward. Step 3: If this part is missing stop right here and get one installed by a qualified guitar repairman.You can get this part from Depending on the guitar you purchased, the tremolo stop may or may not be engaged with the spring block. We will assume it is not engaged and show you how to engage it. Take the 3mm Allen wrench and turn the setscrew until it touches the spring block. Step 4: Now, tighten the springs with the spring claw screws so the spring block is pulled tightly against the setscrew. Step 5: Another way to pull the spring block against the tremolo stop set screw is to add another spring to the spring block and claw. Using this method is preferred because it will be easier to re-float the tremolo after setting up the bridge. 6 11 SETTIN...

Скачать инструкцию

Чтобы скачать, введите 2 цифры: