Оценок - 3, средний балл: 4.3
(
)
)
|
Фрагмент инструкции
Put your hand in a position where you can easily operate the Recording start/stop button, PHOTO button and the Zoom lever. Adjust the length of grip belt so that the memory camcorder is stable when you press the Recording start/stop button with your thumb. 1. Detach the belt. 2. Adjust the length of grip belt. 3. Attach the belt. • • • 1 2 3 preparation USING THE ACCESSORIES Angle Adjustment This memory camcorder has a new swivel handgrip. Its handle turns along with the shooting angle. You can now shoot videos (or photos) freely from high angles to low angles while standing. • Rotate the swivel hand-grip at the most convenient angle. • Please be noticed that using excessive force to insert your hand while the hand strap is adjusted too CAUTION tight may damage the hand strap hook of the memory camcorder. You can rotate it downward up to 180 degrees. English_13 Please be careful not to turn the swivel handle backward as it may cause damage. ATTACHING THE CORE FILTER To reduce electrical interference, attach the core filter to the AC power adaptor. To attach the core filter to power adapter, roll the cable over core fi lter once. Be careful not to damage the cable when attaching the core filter. • • AC power adaptor Wind once! CARDCARDCARD[BATT. RELEASE] CARDCARDCARD[BATT. RELEASE] preparation CONNECTING A POWER SOURCE • There are two types of power source that can be connected to your memory camcorder. • Do not use provided power supply units with other equipment. - The battery pack: used for outdoor recording. - The AC power adaptor : used for indoor recording and playing back. .page 21 Battery Pack installation / ejection Insert It is recommended you purchase one or more additional battery packs to allow continuous use of your memory camcorder. Inserting the battery pack 1. Slide and open the battery slot cover as shown in the diagram. 2. Insert the battery pack into the battery slot until it softly clicks. • Make sure that the SAMSUNG logo is facing up while the set is placed as shown in the diagram. 3. Slide and close the battery slot cover. Ejecting the battery pack 1. Slide and open the battery slot cover and push the battery lock. Eject • Gently push the battery lock in the direction as shown in the diagram to eject the battery out. 2. Pull the ejected battery out in the direction as shown in the diagram. 3. Slide and close the battery slot cover. Switch • Store the battery pack separated from the memory camcorder while not in use. • It is recommended to prepare an additional battery pack for prolonged outdoor use. • Contact your nearest Samsung Electronics Service Centre for purchasing additional battery pack. English_14 Charging the Battery Pack CARD1 5 4 2 3 • Be sure to charge the battery pack before you start using your memory camcorder. • Use IA-BP85ST battery pack only. • The battery pack may be charged a little at the time of purchase. 1. Slide the POWER switch downward to turn off the power. 2. Insert the battery pack to the memory camcorder. .page 14 3. Open the DC IN/USB/AV jack cover. 4. Connect the AC power adaptor to the DC IN jack of your memory camcorder. 5. Connect the AC power adaptor to a wall socket. • The CHG (charging) indicator lights up in orange and showing that the battery pack is charging. • The CHG (charging) indicator lights up in green when the battery is fully charged. .page 16 6. When the battery pack is fully charged, disconnect the AC power adaptor from the memory camcorder. • Even with the power switched off, the battery pack will still discharge if it is left attached to the memory camcorder. It is recommended that you remove the battery pack from the memory camcorder. • Charging the battery pack in a low temperature circumstance may take longer time or fail to fully charge (green indicator will not turn on). CAUTION • Please make sure that there are no foreign substances in plug and socket when you connect AC power supply to the memory camcorder. • Fully charge the battery pack before using. • When using the AC power supply, place it close to the wall outlet. Found with malfunction while in use of memory camcorder, separate the AC power supply immediately from the wall outlet. • Do not use the AC power supply in a narrow and small place, such as between furnishings. • For recording indoors with available wall outlet, it is convenient to use the AC power supply instead of the battery pack. • It is recommended to charge the battery pack in a place with ambient temperature of 10°C ~ 30°C. English_15 preparation Charging indicator Tips for battery identifi cation . The colour of the LED indicates charging status. • If the battery has been fully charged, the charge indicator is green. • If you are charging the battery, the colour of the charge indicator is orange. • If an error occurs while the battery pack in charging, the charging indicator blinks red. Charging state Power Charge On (Mode Select) Off Charging Fully Charged Error LED colour Blue -Orange Green Red (Fli...
Эта инструкция также подходит к моделям:Видеокамеры - SMX-F300BP (11.19 mb)
Видеокамеры - SMX-F300RP (11.19 mb)
Видеокамеры - SMX-F30BP (11.19 mb)
Видеокамеры - SMX-F30LP (11.19 mb)