AEG — putting words into action. 3 4 General The cooker hood can be used : either as an exhaust air appliance (extraction mode) or as a return air appliance (recirculation mode) - filtering through an active carbon filter (optional extra). Notes prior to installation in the extraction mode the exhaust air must not be introduced into a smoke flue or exhaust gas chimney. Introduction of the exhaust air into a shaft used for ventilation of the installation spaces of firerooms is not permitt

NOTE: The terminology “DOUBLE POLE” means that both the live and neutral supplies are swiched and disconnected at the same time. The terminations labelled SUPPLY are for the connection for the internal house wiring and the terminations labelled LOAD are for the appliance. IMPORTANT The wires of the mains lead supplied with this appliance are coloured in accordance with the following code: Blue-Neutral Brown-Live As the colours of the flexible cord of this appliance may not correspond with the co

— Fig. 4. sm • Measure the height between the upper side of the body of the cooker hood and the ceiling (fig. 5). 9 # Set the chimney according to the measured height and stop its run with the two fixing screws 2,9x6,5 mm supplied (fig. 6). • Fix the chimney to the aesthetic top with two screws 2,9x6,5 mm supplied (fig. 7). • From the inside of the hood, fix the aesthetic top with four screws M3x6 supplied (Two each side)(fig. 8). • Fix the upper bracket to the wall, close to the ceiling,

Never use water. • Never do any flambe cooking underneath the cooker hood. It can cause a fire. Remember that overheated fat may spontaneously ignite. Never leave the frying pan unattended. • It is essential that the grease filter is regularly cleaned to help avoid fat dripping on to the hot zone and causing a fire. Read the section on “Maintenance and Cleaning” in the instruction book. Disposal • Prevent accidents when disposing of your cooker hood. Disconnect the power plug from the wall socke

155 D Dunstabzugshaube Cooker hood Hotte aspirante Cappa aspirante Montage- und Gebrauchsanweisung Installation and Operating Instructions Instructions de montage et mode d’emploi Istruzioni di montaggio ed istruzioni per I’uso Contents Introduction...........................................................................23 Extractor version.............................................................,.......23 Filter version...............................................................

Your safety is of paramount importance. If you are unsure about any of the meanings of these warnings contact the Customer Care Department. Installation • Any installation work must be undertaken by a qualified electrician or competent person. • This hood must be installed in accordance with the installation instructions and all measurements adhered to. • If the cooker hood is installed for use above a gas appliance then the provision for ventilation must be in accordance with the Gas Safety Cod

In this case the hood will be slightly more noisy. Fig. 1 Filter Version • The air is filtered through a charcoal filter and returned to the kitchen through the top grill of the outlet pipe. • You will need an original AEG charcoal filter for the filtering function. • Fix the deflector using 2 screws. Fig. 2. • Optionally, the position of the chimney elements can be changed. When using the hood in the filter version the chimney must be fixed at the top, with the air outlet grill at the side. A F

222 D Fume Extractor Hood Installation and Operating Instructions Printed on recycled paper. AEG - putting words into action. 2 Contents Introduction 4 Extraction mode 4 Recirculation mode 5 Electrical connections 6 Technical details 7 Installation 8 Safety warnings for kitchen unit installer 8 Wall unit mounting 10 Wall mounting 11 Hood operation 12 Safety warnings for user 13 Maintenance and care 14 Opening the grid 14 Grease filter 14 Carbon filter 15 Changing the ligh