To interrupt the Intensive speed, press button A or B. H: Light on/off. Should the hood or the controls fail to operate: disconnect the power supply for at least 5 seconds, then turn the hood back on again. Correct ventilation If the cooker hood is to work correctly there must be an underpressure in the kitchen. It is important to keep the kitchen windows closed and have a window in an adjacent room open. Important to know Not applicable for recirculation. Great care must be taken if the hood is
15) After 30 operating hours the letter (F- grease filters) will flash on and off on the display (D) in alternation with the fan speed setting. [ D I o ■ i [j SB 115 I This means that the metal grease filters need to be cleaned! (This operation should be carried out every 30 operating hours!) Proceed as follows to remove and clean the metal filters: Switch of the fan motor by pressing the [o] button. Take the precaution of removing my cartridge fuses from their fuse holders or tripping
Gas, oil in particular should never be left uncovered. • Special care should be taken when using deep fat fryers since the oil in them can overheat and burst into flames. • The risk of a fat fire increases when using dirty oil. • It is extremely important to note that overheating can cause a fire. • Never carry out any flambé cooking under the hood. • Always disconnect the unit from the power supply before carrying out any work on the hood, including replacing the light bulb (take the cartr
It is changed when the top colouring appears on the bottom, i.e. you can see the colour through the filter grille. To remove the filter: a) Remove the filter grille (see fig. 3) b) Take out the saturated filter after removing the clamps Z (fig. 13). c) Fit a new grease filter and replace filter grille. When replacing the grease filter, also wash the filter grille with warm water and mild detergent i.e. washing-up liquid. Replacement grease filters are available from AEG Spare Parts - Tele
Integrated hoods. EFI60012S EFI60013S EFG70023S EFG50022S 70cm canopy hood. n Electronic variable 3 speed slider control 52cm canopy hood. n Electronic variable 3 speed slider control 60cm integrated hood. n Variable 3 speed slider speed control n Twin motors for high performance n Extended vapour guide 60cm integrated hood. n Variable 3 speed slider speed control n Extended vapour guide PERFORMANCE 320m3/h extraction rate PERFORMANCE 510m3/h extraction rate PERFORMANCE 620m3/h extraction rate P
Installation and service . Any electrical installation of the cooker hood must be carried out by a qualified electrician and the hood itself must be installed by someone with experience. Installation made by an unqualified person can lead to loss of function of the cooker hood and possible damage to person and and/or property. . The cooker hood must be at least 50 cm above electric hobs or electric ranges, or at least 65 cm above gas burners or gas ranges. l Ensure that the power cable is not da
The control switches are located on the unit’s front panel: 8160 D - 8190 D • the light switch switches the hood lamp on and off • the motor switch switches the motor on and off, enabling you to select one of the three different speeds. Light switch Motor switch 8260 D - 8290 D • the light switch switches the hood lamp on and off • the motor switch switches the motor off • Speed 1: Speed 1 push-button • Speed 2: Speed 2 push-button • Speed 3: Speed 3 push-button Light switch Speed 3 Speed 2 Moto
Symptom Solution The cooker hood will not start... Check that: The hood is connected to the electricity supply. Check that a fan speed has been selected The cooker hood is not working effectively.. Check that: The fan speed is set high enough for the task. The grease filters are clean. The kitchen is adequately vented to allow the entry of fresh air. If set up for recirculation, check that the charcoal filter is still effective. If set up for extraction, check that the ducting and outlets are no