Оценок - 4, средний балл: 4.8
(
)
)
|
Фрагмент инструкции
15) After 30 operating hours the letter (F- grease filters) will flash on and off on the display (D) in alternation with the fan speed setting. [ D I o ■ i [j SB 115 I This means that the metal grease filters need to be cleaned! (This operation should be carried out every 30 operating hours!) Proceed as follows to remove and clean the metal filters: Switch of the fan motor by pressing the [o] button. Take the precaution of removing my cartridge fuses from their fuse holders or tripping the automatic circuit breaker to ensure the fan motor cannot be switched on accidentally. 1. Remove the grille (Fig. 16). — Open my latch L and swing the grille downwards. — To remove the grille, pull it forwards from the right and release it. Remove the metal filter by operating the stops that fix them to the grille. 38 2. Clean the inner housing using a hot detergent solution only (never use caustic detergents, abrasive powders or brushes). 3. Leave the metal grease filter panel to soak for approximately 1 hour in very hot water with grease-dissolving detergent and then rinse it with very hot water. Repeat the operation if necessary. Load the grease filter panel in a dishwasher, selecting the most intensive washing programme and maximum temperature, at least 65°C. Repeat the operation if necessary. 4. When both metal grease filters have been cleaned and left to dry, replace them by following the above operations in reverse order (front first and then back). 5. Screw the fuses back in or reset the automatic circuit breaker. 6. Proceed as follows to reset the filter saturation display (counter). Select any fan speed using my [©] E or [©] F buttons and then press my [o| B and [©] F buttons at the same time, continuing to hold them down for at least 3 seconds until the flashing letter F stops being shown on the display (D) and then press the [q] button B. Changing the light bulbs Cleaning — Disconnect the unit from the mains power supply. — Remove my cover — Replace the old light bulb with a new light bulb (40 W max.). — If the light does not come on, make sure the bulb has been screwed in correctly before contacting the technical assistance service. Warning: always disconnect the hood from the mains power supply before cleaning it. Never insert pointed objects in the motor’s protective grille. Wash the outside surfaces using a delicate detergent solution. Never use caustic detergents or abrasive brushes or powders. Only ever clean the switch panel and filter grille using a damp cloth and delicate detergents. Attention! Attention! Failure to observe the instructions on cleaning the unit and changing the filters will cause a fire hazard. You are therefore strongly recommended to follow these instructions. 40 MKZ telescopic wall pipe 120 mm outlet hose KLF60/80 activated carbon filter E-Nr. 610 899 004 610 899 007 610 899 421 Technical assistance service You are welcome to telephone our technical assistance service (see list of techn...
Эта инструкция также подходит к моделям:Вентиляторы - 155 D (978.31 kb)
Вентиляторы - 155 D (978.31 kb)
Вентиляторы - 155 D (978.31 kb)
Вентиляторы - 155 D (978.31 kb)