|
Фрагмент инструкции
Attention: the metal grease filters must be removed and washed, either by hand or in the dishwasher, every four weeks. Removing the metal grease filters • Push it towards the back of the unit and then pull it down and out. Fig. 3. Hand washing Soak grease filters for about one hour in hot water with a grease- loosening cleaner, then rinse off thoroughly with hot water. Repeat the process if necessary. Refit the grease filters when they are dry. Dishwasher Place grease filters in the dishwasher. Select most powerful washing programme and highest temperature, at least 65°C. Repeat the process. Refit the grease filters when they are dry. When washing the metal grease filter in the dishwasher a slight discolouration of the filter can occur, this does not have any impact on its performance. • Clean the inner housing using a hand hot solution only(never use caustic detergents, abrasive powders or brushes). Fig. 3 Charcoal filter • The charcoal filter should only be used if you want to use the hood in recirculation mode. • Cleaning/replacing the carbon filter Unlike other carbon filters, the LONGLIFE carbon filter can be cleaned and reactivated. At normal use the filter should be cleaned every second month (when using the hood 2,5 hours per day, in avarage). The best way to clean the filter is in the dishwasher. Use normal detergent and choose the highest temperature (65. C). Wash the filter separately so that no food parts gets stuck on the filter and later causes bad odours. To reactivate the carbon, the filter should be dried in an oven for 10 minutes with a temperature of maximum 100. C. After approximately three years of use, the carbon filter should be replaced with a new one, as the odour reduction capacity will be reduced. • Fitting Remove the grease filters. Remove the frame i which supports the filter h by turning 90° the two knobs g. Insert the charcoal filter inside the frame and put all parts back in their place. Refit the grease filters. Fig. 4. • To remove proceed in the reverse order. • Always specify the hood model code number and serial number when ordering replacement filters. This information is shown on the rating plate located on the inside of the unit. • The charcoal filter can be ordered from your local Service Force Centre. Fig. 4 Fig. 5 Fig. 5 Warning • Failure to observe the instructions on cleaning the unit and changing the filters will cause a fire hazard. You are therefore strongly recommended to follow these instructions. • The manufacturer declines all responsibility for any damage to the motor or any fire damage linked to inappropriate maintenance or failure to observe the above safety recommendations. Changing the light bulbs • Disconnect the cooker hood from the mains supply. • Prior to touching the light bulbs ensure they are cooled down. • Extract the lamp cover by using a small flat screwdriver or similar tool as a lever. • Replace the old bulb with a new one of the same type. • Refit the lamp cover. • If the ligh...
Эта инструкция также подходит к моделям:Вентиляторы - DK 4360 (2.99 mb)
Вентиляторы - DK 4390 (2.99 mb)
Вентиляторы - DK 4360 (2.99 mb)
Вентиляторы - DK 4360 (2.99 mb)