Оценок - 4, средний балл: 3.5
(
)
)
|
Фрагмент инструкции
54 Description of the Appliance • The cooker hood is designed to extract unpleasant odours from the kitchen, it will not extract steam. • The hood is supplied as an extractor unit and can also be used with a recirculation mode by fitting a charcoal filter. Extraction mode • In this mode fumes are extracted to the outside via a hose connected to the coupling ring. Fig. 1 • In order to obtain the best performance the hose should have a diameter equal to the outlet hole. Recirculation mode • The air is filtered through a charcoal filter and returned to the kitchen. Fig. 2 • You will need an original charcoal filter for the recirculation mode. (See Special Accessories). Fig. 1 Top Rear Coupling ring Top Rear Fig. 2 Control Panel • Best results are obtained by using a low speed for normal conditions and a high speed when odours are more concentrated. Turn the hood on a few minutes before you start cooking. The hood should be left on after cooking for about 15 minutes or until all the odours have disappeared. The control switches are located on the unit’s front panel: Light switch Speed 3 Speed 2 Motor switch Speed 1 • the light switch switches the hood lamp on and off • the motor switch switches the motor off • Speed 1: Speed 1 push-button • Speed 2: Speed 2 push-button • Speed 3: Speed 3 push-button Maintenance and Care Warning! Before performing any maintenance operation, isolate the hood from the electrical supply by switching off at the connector and removing the connector fuse. Or if the appliance has been connected through a plug and socket, then the plug must be removed from the socket. Metal grease filter • The purpose of the grease filters is to absorb grease particles which form during cooking and it must always be used, either in the external extraction or internal re-circulation function. Attention: the metal grease filters must be removed and washed, either by hand or in the dishwasher, every four weeks. Removing the metal grease filters • Push it towards the back of the unit and then pull it down and out. Fig. 3. Hand washing Soak grease filters for about one hour in hot water with a grease- loosening cleaner, then rinse off thoroughly with hot water. Repeat the process if necessary. Refit the grease filters when they are dry. Dishwasher Place grease filters in the dishwasher. Select most powerful washing programme and highest temperature, at least 65°C. Repeat the process. Refit the grease filters when they are dry. When washing the metal grease filter in the dishwasher a slight discolouration of the filter can occur, this does not have any impact on its performance. • Clean the inner housing using a hand hot solution only(never use caustic detergents, abrasive powders or brushes). Fig. 3 Charcoal filter • The charcoal filter should only be used if you want to use the hood in recirculation mode. • Cleaning/replacing the carbon filter Unlike other carbon filters, the LONGLIFE carbon filter can be cleaned and reactivated. At normal us...
Эта инструкция также подходит к моделям:Вентиляторы - DK 4360 (2.99 mb)
Вентиляторы - DK 4390 (2.99 mb)
Вентиляторы - DK 4360 (2.99 mb)
Вентиляторы - DK 4390 (2.99 mb)