Войти:
Оценок - 0, средний балл: 4 ( )

Инструкция по эксплуатации Garland, модель GIWOK 5.0 BI (SH/WO/IN 5000)

Производитель: Garland
Размер: 2.53 mb
Название файла:
Язык инструкции:en
Перейти к скачиванию



Фрагмент инструкции


Prior to the first use, HyperTerminal should be configured properly. Garland service requires the following settings listed below: 2400bps, 8bit, no parity, 1 stop bit, hardware protocol. First connect the IR adapter into your PC or laptop computer. Place the IR sensor section onto the ceran glass towards the bottom left hand corner for counter top cookers. Position the IR sensor to the generator. Refer to figure #3 in this section for correct positioning. For all Wok cookers, you will be required to first remove the top wok bowl assembly. Place the IR adapter into the left hand corner, directly over the rectangular opening located on the metal sheet with ferrit stripes. For Wok cookers please refer to figure #4 for IR adapter positioning. Start HyperTerminal and put the access name, e. g. IR2400.ht. Select the communication via COM1 (or where your IR adapter has been connected). Select the following settings: 2400 Bits/sec., 8 Databits, no parity, 1 Stop bit, Hardware protocol. Setting IR 2400.ht should be saved so that there will be no need to put them again and the connection can be built-up by selecting symbol IR2400.ht. Figure # 3 – IR Adapter position for counter top (base-line) cookers For all counter top induction cookers (excluding all WOK models), position the IR adapter tool to the lower left hand corner of the ceran glass as shown in photo. Figure # 4 – IR Adapter position for built-in (install-line) cookers IR Adapter to be positioned directly over rectangular opening, shown in photo. IR Adapter tool in position. Place Wok Bowl top assembly back onto cooker as shown and, begin testing using IR adapter tool. SECTION 10 – WIRING BLOCK SCHEMATIC Main (Power) FilterL1L2L3PE(230V L2)(208V L2)(240V L2) ACDCPower Supply12VAC24VDC5VDC-5VDCGNDRectifierACDC12VAC5VDC24VDCT B24VDCPotentiometerLEDIRAdapterFanCPUIGBT - TransistorDCAC-5VDC24VDCT KKT Cu1T CU2CoilRTCSSensors ...

Эта инструкция также подходит к моделям:
Варочные панели - GIWOK 3.5 (SH/WO 3500) (2.53 mb)
Варочные панели - GIU 1.5 (BH/BA 1500) (2.53 mb)
Варочные панели - GIU 1.8 (BH/BA 1800) (2.53 mb)
Варочные панели - GIU 2.5 (BH/BA 2500) (2.53 mb)

Напишите ваш отзыв об устройстве



Текст отзыва
Ваше имя:
Введите две цифры:
capcha





Категории