Оценок - 1, средний балл: 4
(
)
)
|
Фрагмент инструкции
It is important that the following maintenance procedures be performed as recommended. Such preventative maintenance measures will extend the life of this equipment and will provide trouble free operation. The length of time used each and the use frequency will determine how often maintenance is required. Every cooker must be checked at least once a year. The following routine maintenance should and must be completed periodically. Fan Function of the cooker can only be guaranteed if all electronic components are operated within their normal working conditions (temperatures). • The air inlet and air outlet slots must not be blocked. • The air filter must not be blocked by dirt or grease. • The airducts must be free of dirt. • The air must circulate unhindered through the heat sink (no hindrance). • The fan is correctly installed and in good operation. • The heat sinks are installed correctly and in place. Check Induction coil • Mechanical, screw mountings (screws all tightened)? • Coil adhesive (coil wire in place o.k.)? • Ferrites (all mounted and in place o.k.)? • Copper coil (wire in place o.k.)? • Coil connections to power board ok? (Refer to the following Figures #1 and #2 for correct and incorrect, coil connections). General Checks • Protection connection grounded? • Screwed connections all tight? • Isolations of cables? • Any kind of liquids that have entered the cooker? • Dirt in the cooker? Figure # 1 - Correct Coil (Spoil) Connection This connection must be well insulated and slightly bent upwards so the terminal end, does not make contact with the high voltage section on the power board. Coil wires must be tightly twisted together and precisely placed. Coil terminals must be connected in the direction shown in photo. Figure # 2 – Examples of Incorrect Coil (Spoil) Connections Coil wires not twisted tightly together or precisely placed. Coil terminals connected in the incorrect direction. Coil terminals connected in the incorrect direction. Coil terminals connected in the incorrect direction. SECTION 6 – FAULT FINDING General Information CAUTION Do not attempt to open the cooker when it is connected to the power supply. Dangerous high voltage components will be exposed! The induction cooker may only be serviced by authorized service personnel. Should the (Ceran Glass) become broken or cracked, turn off the cooker immediately and disconnect the electrical power supply to the unit. Do not touch any parts inside the cooker. Before replacing a part, check the wiring. Pay close attention to the following faults: • Broken cables • Squeezed cables • Defective isolations of cables • Bad soldering joints You must not attempt to do any repairs on the circuit boards. It is important, however to do routine maintenance after every repair see Section 5 Maintenance/Service for details. Error Messages Order of error message for error code 1-8: The indicator lamp located directly above the control knob flashes for an interval of 0.6 seconds. The number o...
Эта инструкция также подходит к моделям:Варочные панели - GIWOK 3.5 (SH/WO 3500) (2.53 mb)
Варочные панели - GIU 1.5 (BH/BA 1500) (2.53 mb)
Варочные панели - GIU 1.8 (BH/BA 1800) (2.53 mb)
Варочные панели - GIU 2.5 (BH/BA 2500) (2.53 mb)