|
К этому устройству также есть другие инструкции:
Фрагмент инструкции
HP StoreEver Enterprise
CAUTION:
Parts can be damaged by
Systems Library (ESL) G3 Tape
electrostatic discharge. Keep parts in their
containers until needed. Make sure that you are
Library
properly grounded when touching static sensitive
components.
Calibration Target
CAUTION:
Calibration targets are in specific
Replacement Instructions
locations in the library. When targets are not
in the appropriate locations, they are considered
“out of range” and will cause calibration errors.
Abstract
NOTE:
When replacing calibration targets,
This document describes how to remove and replace an
make sure that the plastic rectangle is completely
existing calibration target in an ESL G3 Tape Library.
seated on the magazine.
Inspect the contents of the kit
The kit contains one calibration target.
Remove the existing calibration target
1.
On the operator panel, press the Robotics Enabled
button to turn off power to the picker assembly
and return it to the home position.
2.
Open the access (front) door.
3.
Pull the top of the calibration target toward you
until it unsnaps from the magazine.
© Copyright 2013 Hewlett-Packard Development Company, L.P.
Printed in the US
HP Part Number: QN998-96103
Published: May 2013
Edition: 2nd
*QN998-96103*
Page 1
...Эта инструкция также подходит к моделям:
Устройства обработки данных - HP StoreEver ESL G3 300 slot Tape Library (88.34 kb)
Устройства обработки данных - HP StoreEver ESL G3 700 slot Tape Library (88.34 kb)
Устройства обработки данных - HP StoreEver ESL G3 1500 slot Tape Library (88.34 kb)
Устройства обработки данных - HP StoreEver ESL G3 3000 slot Tape Library (88.34 kb)