Оценок - 0, средний балл: 0
(
)
)
|
К этому устройству также есть другие инструкции:
Фрагмент инструкции
HP StoreEver Enterprise
CAUTION:
Parts can be damaged by
Systems Library (ESL) G3 Tape
electrostatic discharge. Keep parts in their
containers until needed. Make sure that you are
Library
properly grounded when touching static sensitive
components.
I/O Management Unit
NOTE:
The I/O management unit cooling
Cooling Assembly
assembly can be replaced without taking the
Replacement Instructions
library offline. However, if the library is not
taken offline for the replacement procedure, an
event will be posted.
Abstract
This document describes how to remove and replace an
existing I/O management unit cooling assembly in an ESL
Inspect the contents of the kit
G3 Tape Library.
The kit contains one I/O management unit cooling fan
assembly.
You will also need the ESD strap that shipped with the
ESL G3 and a Phillips screwdriver.
Remove the existing cooling assembly
CAUTION:
This is a time-sensitive procedure.
You must remove and replace the I/O
management unit cooling assembly in five
minutes or less. Taking more than five minutes
to complete this procedure could result in
damage to the library.
1.
Open the service door of the module that contains
the cooling assembly to be replaced.
2.
Attach the ESD strap to your wrist and to an
unpainted surface inside the door.
3.
Locate the I/O management unit cooling assembly
to be replaced.
© Copyright 2013 Hewlett-Packard Development Company, L.P.
Printed in the US
HP Part Number: QN998-96090
Published: May 2013
Edition: 2nd
*QN998-96090*
Page 1
...Эта инструкция также подходит к моделям:
Устройства обработки данных - HP StoreEver ESL G3 300 slot Tape Library (118.57 kb)
Устройства обработки данных - HP StoreEver ESL G3 700 slot Tape Library (118.57 kb)
Устройства обработки данных - HP StoreEver ESL G3 1500 slot Tape Library (118.57 kb)
Устройства обработки данных - HP StoreEver ESL G3 3000 slot Tape Library (118.57 kb)