Войти:
Оценок - 0, средний балл: 0 ( )

Инструкция по эксплуатации HP, модель HP StoreEver ESL G3 100 slot Tape Library

Производитель: HP
Размер: 220.18 kb
Название файла:
Язык инструкции:en
Перейти к скачиванию



К этому устройству также есть другие инструкции:

Фрагмент инструкции





Remove the power supply from the HDEM
Install the power supply in the HDEM
1.
Vary off the tower using the operator panel on
1.
Using the external handle on the power supply,
the HDEM service access door.
slide the power supply onto the supporting rails
at the top of the HDEM and into place.
2.
Tighten the thumbscrews to hold the power supply
in place.
3.
Attach the power cable to the replacement power
supply.
4.
Turn on the replacement power supply using the
external power switch and close the HDEM service
access door.
5.
Vary on the tower using the operator panel on
the HDEM service access door.
The HDEM power distribution box is built to allow
for two completely redundant power supplies. The
following image should be used as a guide when
routing power cables within the HDEM.
1. Indicator light
2. Enable/Disable button
The LED on the operator panel will turn amber
when the tower is varied off.
2.
Turn off the power supply to be replaced, using
the power switch on the power supply itself.
1. Power plugs
Prepare the library for use
1.
Detach the ESD strap and close the service access
door.
2.
If the library was powered off for this procedure,
press the Power button on the indicator panel to
power it back on.
3.
Remove the power cable from the power supply
to be replaced.
The library begins to boot up. A library with only
a few drives usually will be fully powered on and
4.
Unscrew the thumbscrews holding the power
ready for use within 10 minutes. However, if a
supply in place.
library is large with a high number of drives, it
5.
Using the external handle on the power supply,
can take more than an hour for the library to fully
pull it towards you to remove the power supply.
power on, complete its discovery process, and
become ready for use. During the power on
process, the Robotics Enabled indicator flashes.
Page 2


...

Эта инструкция также подходит к моделям:
Устройства обработки данных - HP StoreEver ESL G3 300 slot Tape Library (220.18 kb)
Устройства обработки данных - HP StoreEver ESL G3 700 slot Tape Library (220.18 kb)
Устройства обработки данных - HP StoreEver ESL G3 1500 slot Tape Library (220.18 kb)
Устройства обработки данных - HP StoreEver ESL G3 3000 slot Tape Library (220.18 kb)

Напишите ваш отзыв об устройстве



Текст отзыва
Ваше имя:
Введите две цифры:
capcha





Категории