Оценок - 3, средний балл: 4.3
(
)
)
|
Фрагмент инструкции
Extend fully. or another cordless phone. This unit can be mounted on a wall. To Power Outlet Screws and Socket OR 8.3 cm For Australia To Telephone Plug For New Zealand To Single-Line Telephone Jack Wall Template 8.3 cm 2 2 Replace the battery and close the cover. .Insert the battery plug into the connector as shown in the picture. .Be sure wires are free from being pressed by the battery body or the handset cover. 3 3 Make sure to charge the new battery for about 15 hours. 1 1 Pull down the handset hook until it locks, so the tab holds the handset. 2 2 Install screws using the wall template below. Connect the AC adaptor and telephone line cord. 3 3 Mount the unit, then slide down. .Extend the antenna fully. Things You Should Know Section 6 6-E Before Requesting Help Problem Cause and Remedy The unit does not work. .Check the settings (1-C). .Charge the battery fully (6-A). .Clean the charge contacts and charge again (6-A). .Install the battery properly (1-C, 6-B). .Place the handset on the base unit and unplug the AC adaptor to reset. Plug in, and try again. .Re-insert the handset battery and place the handset on the base unit. Try again. .KX-TC1200AL and KX-TC1200NZ are not designed to be used with rotary (pulse dialling) services. An alarm tone sounds .You are too far from the base unit. Move when you press (TALK). closer and try again. .Place the handset on the base unit and try again. .Plug in the AC adaptor. .Extend the base unit antenna fully. Static, sound cuts .Locate the handset and the base unit away in/out, fades. from other electrical appliances (6-C). Interference from other .Move closer to the base unit. electrical units. .Extend the base unit antenna fully. .Press (CH)to select a clearer channel. The unit does not ring. .The ringer volume is set to OFF. Press For New Zealand Customers (RINGER)when the TALK indicator light Panasonic New Zealand operates a toll free Customer Support Centre. is off (2-B). Please phone 0800 Panasonic (0800 726276) for assistance. 6-F Adding Another Phone This unit will not function during a power failure. To connect a standard telephone on the same line, use a telephone double adaptor. Standard Telephone Telephone Line Cord To Socket (Optional) Telephone Double Adaptor Standard Telephone Telephone Line Cord T-Adaptor To Single-Line Telephone Jack For Australia For New Zealand Problem Cause and Remedy While storing a phone number, the unit starts to ring. .To answer the call, press (TALK). The program will be cancelled. Store the number again. You cannot store a phone number in memory. .You cannot store a number while the unit is in the talk mode. .Do not pause for over 60 seconds while storing. You cannot redial by pressing (REDIAL). .If the last number dialled was more than 24 digits long, the number will not be redialled. (HANDSET\LOCATOR) does not function. .The handset is too far from the base unit or is engaged in an outside call. The RECHARGE indicator flashes or the unit beeps intermittently. ....
Эта инструкция также подходит к моделям:Планшеты - KX-TC1200NZW (375.16 kb)
Планшеты - KX-TC1200NZB (375.16 kb)
Планшеты - KX-TC1200ALW (375.16 kb)
Планшеты - KX-TC1200ALS (375.16 kb)