Оценок - 5, средний балл: 4.4
(
)
)
|
Фрагмент инструкции
. Electrostatic discharge (ESD) can damage electronic components. Before touching a memory module, ensure the following: . The procedures described in this document assume user familiarity with the general terminology associated with personal computers and with the safety practice and regulatory compliance requirements for using and modifying electronic equipment. . Turn off your computer and disconnect it from its power sources (battery pack and AC adapter) and from any telecommunication links or networks before you remove any cover or panel from the computer. Failure to do so may result in personal injury or equipment damage. . ESD can damage memory modules and other components. Install the memory module only at an ESD workstation. If such a station is not available, do not work in a carpeted area, and do not handle materials that produce or hold static electricity (cellophane wrappers, for example). Ground yourself by maintaining contact with an unpainted metal portion of the chassis while performing the procedure. Upgrading Your VAIO Computer > Adding and Removing Memory n136 N . Do not open the memory module package before you are ready to change the module. The package protects the module from ESD. . Use the special bag supplied with the memory module or wrap the module in aluminum foil to protect it from ESD. . Introducing any liquids, foreign substances, or objects into the memory module slots or other internal components of your computer will result in damage to the computer and any repair costs will not be covered by the warranty. . Do not place the memory module in a location subject to: . Heat sources such as radiators or air ducts . Direct sunlight . Excessive dust . Mechanical vibration or shock . Strong magnets or speakers that are not magnetically shielded . Ambient temperature of more than 35°C or less than 5°C . High humidity . Handle the memory module with care. To avoid injuries to your hands and fingers, do not touch the edges of the components and circuit boards inside your computer. Upgrading Your VAIO Computer > Adding and Removing Memory n137 N Removing and Installing a Memory Module To change or add a memory module 1 Shut down the computer and disconnect all peripheral devices. 2 Wait about an hour until the computer cools down. 3 Unscrew the two screws (1), slide the bottom cover in the direction of the arrow (2), and remove the cover. ! Be careful not to lose the removed screws. 4 Touch a metal object to discharge static electricity. 5 Remove the battery pack (page 24). Upgrading Your VAIO Computer > Adding and Removing Memory n138 N Remove the currently installed memory module as follows: . Pull the latches in the direction of the arrows (1). The memory module is released. . Make sure that the memory module tilts up and then pull it out in the direction of the arrow (2). Remove the new memory module from its packaging. Upgrading Your VAIO Computer > Adding and Removing Memory n139 N Slide the memory module into the memory module slot and push it in until it clicks into place. ! Do not touch any components on the motherboard other than the memory module. Be careful not to touch the wires and the projections inside the bottom cover. Be sure to insert the connector edge of the memory module into the slot while aligning the notch on the module with the small projection in the open slot. Do not force the memory module into the slot in a wrong orientation, as it may cause damage to the slot and the module. Replace the cover and the removed screws and then tighten the screws. 10 Turn on the computer. Upgrading Your VAIO Computer > Adding and Removing Memory n140 N Viewing the Amount of Memo...
Эта инструкция также подходит к моделям:Ноутбуки - VPCSA3C5E (3.09 mb)
Ноутбуки - VPCSA3J1E_XI (3.09 mb)
Ноутбуки - VPCSA3L9E_XI (3.09 mb)
Ноутбуки - VPCSA3M9E_XI (3.09 mb)