Оценок - 4, средний балл: 3.5
(
)
)
|
Фрагмент инструкции
2METER SELECT switch This selects the signal source whose level will be shown by the level meters. When the switch is down ( ) The level meters will show the output level of the GROUP buses 1–4. When the switch is up ( ) The two level meters at the left will show the output level of the ST bus, and the two level meters at the right will show the output level of either the PFL/AFL bus or the TAPE IN jacks (page 17, 4 in the connector section), depending on the setting of the TAPE IN switch (3). Master controls 15 Master controls 15 4C-R MONITOR LEVEL (control room monitor level) control This adjusts the level of the signal that is sent to Tip (hot) the C-R OUT jacks. It does not affect the output 1/4" TRS phone plug Ring (cold) signal of the PHONES jack. 5PHONES LEVEL (headphone) jack Sleeve (ground) This adjusts the level of the signal that is sent to the PHONES jack. It does not affect the output signal of the C-R OUT jacks. ON METER SELECT from GROUP OUT 1 from GROUP OUT 4 from GROUP OUT 3 from GROUP OUT 2 from STEREO OUT L from STEREO OUT R C-R OUT PHONES ST TAPE IN C-R MONITOR LEVEL LEVEL PFL/AFL LR BA BA BA BA PHONES L R ST RL L TAPE IN R Tape input and monitor output signal flow —Owner’s Manual 16 Front and rear panel 16 Front and rear panel Meter section This is a peak level meter that shows (according to the setting of the METER SELECT switch, page 14) the output levels of GROUP buses 1–4, the ST bus, and the PFL/AFL bus, and the input level of the TAPE IN jacks. The status of the mixer’s power supply and phantom power is also shown here. 1 PEAK +8 +5 +3 +1 0 –1 –3 –5 –7 –10 –15 –20 1Level meters When the METER SELECT switch (page 14) is pressed inward ( ), the four level meters will show the output levels of GROUP buses 1–4. When the METER SELECT switch is in the upward position ( ), the two level meters at left will show the output level of the ST bus, and the two level meters at right will show either the output level of the PFL/AFL bus or the input level of the TAPE IN jacks (page 17, 4 of the connector section), depending on the setting of the TAPE IN switch (page 15, 3 of other controls/connectors). POWER PHANTOM L R L R 1 STEREO PFL•AFL/TAPE IN 2 3 4 PEAK +8 +5 +3 +1 0 –1 –3 –5 –7 –10 –15 –20 2 3 2POWER indicator This indicator shows the on/off status of the mixer’s power supply. When the POWER switch (page 20, E in the connector section) has been pressed to turn on the power, this indicator will light. 3PHANTOM (phantom power supply) indicator This indicator shows the on/off status of the phantom power supply. When the PHANTOM +48 V switch (page 14, 1 in other controls/connectors) has been slid to turn on the phantom power, this indicator will light. —Owner’s Manual Connectors 17 Connectors 17 s DC B A 0 INPUT B INPUT B INPUT AINPUT A 21L 22R 23L1R2R 1L(MONO) (MONO) 2LLRLR 24R 21L 22RRR LL 123456 1234 POWER ON/ OFF 23L 24R INSERT I/O 0dB INPUT B INPUT A INSERT I/O 0dB INPUT B INPUT A INSERT I/O 0dB INSERT I/O OUT IN REC OUT –10dBVSTEREO OUT +4dBVMONO OUT +4dBV C-R OUT +4dB GROUP OUT +4dB AUX OUT +4dB (BALANCE) ST INSERT I/O 0dB AUX RETURN +4dB TAPE IN –10dBV 9 8 7 E 12 34 1AUX OUT jacks 1–6 These are TRS phone output jacks (balanced) that individually output the signals of AUX buses 1–6. Nominal level is +4 dB. These jacks can be connected to your foldback system or to the inputs of external effect processors. The pin wiring is shown in the following diagram. Tip (hot) 1/4" TRS phone plug Ring (cold) Sleeve (ground) 2MONO OUT jack This is a XLR-3-32 type connector (balanced) which outputs a monaural mix of the main stereo output. Nominal output level is +4 dB. The pin wiring is shown in the following diagram. 2 (hot) Female XLR connector 3 (cold) 56 3STEREO OUT jacks These are XLR-3-32 type connectors (balanced) which output the main stereo signal that has passed through the STEREO fader. Nominal output level is +4 dB. The pin wiring is shown in the following diagram. 2 (hot) Female XLR connector 3 (cold) 1 (ground) 4TAPE IN connector These are phono inputs jacks (unbalanced) for connecting external line level devices. Nominal level is –10 dBV. The pin wiring is shown in the following diagram. Phono plug Tip Sleeve 1 (ground) —Owner’s Manual 18 Front and rear panel 18 Front and rear panel page 12, 3in the STEREO/ MONO control section). The pin wiring is shown in the following diagram. Phono plug Tip Sleeve 7INPUT A jacks 1–20 {1–12 on the GF16/12, 1–8 on the GF12/12} These are XLR-3-31 type input connectors (balanced) for the monaural input channels. Nominal input level is –16 dB to –60 dB when the pad switch (page 6, 1 of the monaural input channel section) is off, and +10 dB to –34 dB when the pad switch is on. When the PHANTOM +48 V switch (page 14, 1 of other controls/connectors) is on, DC +48 V phantom power is supplied to pins 2/3. The pin wiring is shown in the following diagram. 1 (ground) Male XLR connector 3 (cold) 6INPUT A jacks 21–24 {13–16 on the GF16/ 12, 9–12 on the GF12/12} T...
Эта инструкция также подходит к моделям:Музыкальные инструменты - GF12/12 (602.37 kb)
Музыкальные инструменты - GF16/12 (602.37 kb)