• Never leave the chimney unsupervised when in operation. • Always place the chimney on an even base. Otherwise, the chimney could tip over and lead to a fire. • Never place the chimney close to heat sources, and protect the power cord from damages. Therefore, do not keep the power cord lying in front of the chimney. • Do not use the chimney with a time switch or a similar appliance. In case of auto-start, there exists a fire hazard if the chimney is covered or has been set up incorrectly. Risk

Before connecting the heater check that the supply voltage is the same as that stated on the heater. Electrical WARNING – THIS APPLIANCE MUST BE EARTHED This heater must be used on an AC ~ supply only and the voltage marked on the heater must correspond to the supply voltage. Before switching on, please read the safety warnings and operating instructions. For your convenience, the heater is fitted with a rewireable plug incorporating a 13 amp fuse. In the event of replacing the fuse in the plug

Dimensions (millimetres) Installation and Operating Instructions Dimplex Chalbury Fire Model(s) : CHB20BR & CHB20CH 08/19130/2 Issue 2 Important Safety Advice: When using electrical appliances, Basic precautions should always be followed to reduce the risk of fire, electrical shock, and injury to persons, including the following: • If the appliance is damaged, check with the supplier before installation and operation. • Do not use outdoors. • Do not use in the immediate surroundings of a bath, s

The warranty will not apply if, in the sole judgement of the Company, damage or failure has resulted from accident, alteration, misuse, abuse, incorrect installation, or use for purposes other than a Dimplex electric fireplace. The foregoing is in lieu of all other warranties expressed, implied or statutory, and the company neither assumes, nor authorizes any person to assume for it any other obligation, or liability in connection with sold product. CONSERVER CE MANUEL POUR LE CONSULTER AU BESOI

The warranty will not apply if, in the sole judgement of the Company, damage or failure has resulted from accident, alteration, misuse, abuse, incorrect installation, or use for purposes other than a Dimplex electric fireplace. The foregoing is in lieu of all other warranties expressed, implied or statutory, and the company neither assumes, nor authorizes any person to assume for it any other obligation, or liability in connection with sold product. CONSERVER MANUEL POUR LE CONSULTER AU BESOIN.C

Return unit to authorized service facility for examination, electrical or mechanical adjustment, or repair. 4. Do not run the cord under carpeting. Do not cover cord with throw rugs, runners, or the like. Arrange cord away from traffic area and where it will not be tripped over. 5. To disconnect the unit, turn the controls off, then remove the plug from the outlet. 6. Do not modify the electric fireplace. Use it only as described in this manual. Any other use not recommended by the manufacturer

Plug unit into another outlet or install unit on a dedicated 15 amp circuit Unit turns on or off by itself Remote control has a similar frequency to other remotes in the area Select alternative frequency code Page 2 Radio frequency disturbance from outside sources Lights dim in room while the unit is on Unit is drawing close to circuit current rating Move the unit to another outlet or install unit on a dedicated 15 amp circuit Power cord gets warm Normal operation The power cord may get

The warranty will not apply if, in the sole judgement of the Company, damage or failure has resulted from accident, alteration, misuse, abuse, incorrect installation, or use for purposes other than a Dimplex electric fireplace. The foregoing is in lieu of all other warranties expressed, implied or statutory, and the company neither assumes, nor authorizes any person to assume for it any other obligation, or liability in connection with sold product. CONSERVER CE MANUEL POUR LE CONSULTER AU BESOI

The warranty will not apply if, in the sole judgement of the Company, damage or failure has resulted from accident, alteration, misuse, abuse, incorrect installation, or use for purposes other than a Dimplex electric fireplace. The foregoing is in lieu of all other warranties expressed, implied or statutory, and the company neither assumes, nor authorizes any person to assume for it any other obligation, or liability in connection with sold product. CONSERVER CE MANUEL POUR LE CONSULTER AU BESOI

Rough-in framing dimensions will vary for different drywall thicknesses. 2. Allow 8” of service cable for connecting to the junction box on the fireplace. Remove the outer jacket and strip the individual conductors %” from the end. 3. Loosen the screw securing junction box cover and remove the cover (FIGURE 1). 4. Remove knockouts if necessary or use the provided cable clamp. 5. Place unit in position in the opening, level with shims if necessary and attach unit to frame using nailing flang