From its high tech detachable control panel to finned cast almuinum transmitter heatsink it incorporates features found on no other CB. These features include full surface mount technoloy, fiberglass printed circuit board, dual power output stage, and a digital information screen using a black matrix LCD (liquid crystal display). All the features are under microprocessor control for increased function and reliability. Your Midland 79-290 assures you of having the ultimate technology in a CB radi

The full 10channel weather receiver allows use on all current and future NOAA weather bureau channels plus Canadian and international channels. The unit incorporates microprocessor controlled PLL circuitry for precise tuning and increased function. Receiver noise and interference can now be largely eliminated by the new ESP2™ noise reduction system. Also included is a backlighted Liquid Crystal Display (LCD) digital information center that out- dates CB’s with LED readouts. How to install your M

The NWR/SAME decoding allows you to hear only messages concerning the area concerning you. You now have a choice as to what information will be brought to you. No more will you be awakened to hear of a problem many miles from your home that will not affect you. A clock with alarm is also featured. The 74-200 has an emergency battery backup system for use if you lose power. It will provide up to three hours of operation if power fails. The 74-200 NWR/SAME Weather / All Hazard Monitor is the lates

In this book… IN THIS BOOK…................................................................................................................................................. 2 WARNING NOTES ................................................................................................................................................. 3 FCC LICENSING INFORMATION............................................................................................................................ 3 SAFETY ....

.. If the status LED blinks red once every five seconds in standby, the battery needs charging. When a low battery condition is detected, the radio will automatically revert to low power when transmitting to help prolong the battery's life. If beeps are enabled, two short beeps will be heard before each transmission indicating the radio has automatically switched to low power mode. Sending a 2-tone/selective call or emergency call Your radio may have been programmed to send a 2-tone or selective

The LED indicator will glow red indicating the battery is charging. 5. The rapid charger will fully charge the 1300 mAH NiMH battery in approximately 1.5 hours. The rapid charger will change to a green LED and switch to a trickle charge rate when a full charge is detected. The standard rate charger will charge at a constant rate (requires about 12 hours to fully charge a dead battery) and batteries should not be left in the charger longer than 15 hours. The LED of the standard rate charger does

If you press the upper function button for less than two seconds the monitor mode will be activated while pressed and deactivated when released. For details, please see the “Monitoring the channel” section. .. If you press the upper function button for more than two seconds the monitor mode will latch on. To turn the monitor mode off, press and release the upper function button. For details, please see the “Monitoring the channel” section. [8] PTT (Push to talk) button. The PTT button must be pr

Midland Radio Corporation subscribes to the same safety standard for the use of its products. Proper operation of this radio will result in user exposure far below the Occupational Safety and Health Act (OSHA) and FCC limits. ? DO NOT transmit for more than 50% of total use time (50% duty cycle). Transmitting more than 50% of the time can cause FCC RF exposure compliance requirements to be exceeded. ? This radio is NOT approved for use by the general population in an uncontrolled environment. Th

and 19 • Backlit LCD - 1 - Index Introduction 3 Package Includes 4 Installing the Batteries 5 Quick Start (Portable) 6 Quick Start (Mobile) 7 Controls and Indicators 8 Functions and Controls 9-10 LCD Indicators 11 CB Specifications 12 Weather Receiver Specifications 13 CB Accessories 14 Accessories Order Form 15 Warranty Information 16 MIDLAND Family Products 17 - 2 - Introduction Your 75-822 represents the state-of-the-art in high-tech engineering. It is designed for 40 Channel Citizen Band ope

Use the and keys to select the desired bank. Press the A key to enable (e) or disable (D) the bank for scan. Press the and keys to select another bank or press B D C or to exit. Channel Scan Edit To add or remove a channel in the current bank from the scan list, press and hold the Scan programmable button for two seconds. Use the and keys to select the desired channel. Press the A key to enable (e) or disable (D) the channel in the scan list. Press the and C keys to D select another channel or p