Оценок - 2, средний балл: 4.5
(
)
)
|
Фрагмент инструкции
This product is ENERGY STAR® compliant when used with 120 Watt bulbs. Models 3108677/3108651/3108669 Note: Installation of this light control should be done only by those with experience in 120 Volt household wiring. Some local codes may require that a licensed electrician install the light control. This light control automatically turns on lights when motion is detected. Two lamp holders are provided. The lamp holders are rated at 150 watts max. each. 1. Installation Caution: Always turn the circuit breaker off when wiring the fixture. 1. Remove the existing fixture. 2. The plastic hanger can be used to hold the fixture while wiring. The small end of the plastic hanger can be threaded through the hole in the center of the cover plate. The small end then goes into one of the slots on the mounting strap. 3. Connect the light control as shown in Figure 1: • Black sensor wire to the black (HOT) house wire. • White sensor wire to the white (NEUTRAL) house wire. House ground wire to greenground screw on fixture. Black to black White to white From House Push the rubber plug firmly into place Figure 1 - Wiring at Junction Box Plate 4. Attach the fixture to the mounting strap with the center mounting bolt. Use a weatherproof sealant to seal the fixture to the junction box. 5. Install the protective lamp shields on the lamp holders by lining up the groves on the narrow end of the shields with the dimples in the lamp holders, push the shields into the lamp holders and turn clockwise slightly. 6. Install the lamps in the lamp holders. Do not over tighten. 7. Adjustment lamp holders. The lamps should be at least 1 inch away from the sensor. Caution: Do not mount the sensor above or touching the lamps (keep 1 inch or more from the lamps). The sensor bottom must be facing down for best coverage and to avoid water damage and electrical shock. Note: For under-eave installation, rotate the sensor head 180° by bending the sensor towards the clamp bracket. Rotate the sensor bottom clockwise away from the bracket. 2. Aiming The coverage area for the sensor is shown in Figure 2. The sensor should be aimed so that the motion to be detected is in front of and across the coverage area. The sensor should be aimed looking out at a horizontal angle. To reduce false triggering, point the sensor away from traffic areas, air conditioners, dryer vents, water pools, or anything which may move or change temperature rapidly. 180° 8 Ft. 70 Ft. Figure 2 - Coverage Angles 3. Testing Turn the power back on at the circuit breaker. Turn the light switch on. Note: When first turned on wait about 1 1/2 minutes for the circuitry to calibrate. Put the TIME switch on the bottom of the sensor in the TEST position. You can now walk in front of the unit and the lights will come on for about 5 seconds. The TEST mode works both day and night. Walk through the coverage area and point the sensor to obtain the desired coverage area. Adjust sensitivity as needed. 4. Operation For motion sensing, put...
Эта инструкция также подходит к моделям:Видеонаблюдение - 3108669 (448.03 kb)
Видеонаблюдение - 3108677 (448.03 kb)