Оценок - 2, средний балл: 3
(
)
)
|
Фрагмент инструкции
5. Install the protective lamp shields on the lamp holders by lining up the groves on the narrow end of the shields with the dimples in the lamp holders, push the shields into the lamp holders and turn clockwise slightly. 6. Install the lamps in the lamp holders. Do not over tighten. 7. Adjustment lamp holders. The lamps should be at least 1 inch away from the sensor. Caution: Do not mount the sensor above or touching the lamps (keep 1 inch or more from the lamps). The sensor bottom must be facing down for best coverage and to avoid water damage and electrical shock. Note: For under-eave installation, rotate the sensor head 180° by bending the sensor towards the clamp bracket. Rotate the sensor bottom clockwise away from the bracket. 2. Aiming The coverage area for the sensor is shown in Figure 2. The sensor should be aimed so that the motion to be detected is in front of and across the coverage area. The sensor should be aimed looking out at a horizontal angle. To reduce false triggering, point the sensor away from traffic areas, air conditioners, dryer vents, water pools, or anything which may move or change temperature rapidly. 180° 8 Ft. 70 Ft. Figure 2 - Coverage Angles 3. Testing Turn the power back on at the circuit breaker. Turn the light switch on. Note: When first turned on wait about 1 1/2 minutes for the circuitry to calibrate. Put the TIME switch on the bottom of the sensor in the TEST position. You can now walk in front of the unit and the lights will come on for about 5 seconds. The TEST mode works both day and night. Walk through the coverage area and point the sensor to obtain the desired coverage area. Adjust sensitivity as needed. 4. Operation For motion sensing, put the ON-TIME switch on the bottom of the sensor in the 1, 5 or 10 minute position. When motion is detected, the lights will come on the selected time. Note: The photocell keeps the lights from turning on in daylight. To keep lights on all night, flip the light switch off for 1 second then back on. Turning the light switch off for 1 second then back on will return the control to the motion sensing mode. At dawn, the control will return to the motion sensing mode and shut off. Specifications: Total Lighting Wattage...................... Up to 300 Watts Maximum Lamp Holder Wattage ............... Up to 150 Watts Maximum each Range ............................................................................ up to 70 ft. Time Delay ...................................................... 1, 5, or 10 minutes Caution: This product is to be used with a U.L. listed rain tight or wet location suitable outlet box. Depending on the installation, additional hardware may be required. © 2003 595-5751-02 Lampara detectora ® del movimiento Como socio de ENERGY STAR®, Heath®/Zenith ha determinado que este producto cumple con las pautas de ENERGY STAR® con respecto a eficiencia de energia. Este producto esta en conformidad con ENERGY STAR® cuando se usa con focos de 120 vatios. Cuidado:...
Эта инструкция также подходит к моделям:Видеонаблюдение - 3108651 (448.03 kb)
Видеонаблюдение - 3108677 (448.03 kb)