Оценок - 4, средний балл: 4
(
)
)
|
Фрагмент инструкции
However, only the selected surface Burner will lite. 4. Visually check that zone A & B of the dual burner has lit. 7. When both zones are lit, continue to turn the control knob counterclockwise between dual Hi & LO to adjust to the desired flame size for both burners together. Note: The markings between the Dual Hi and LO settings on the control knob adjust the flame size for both zone A & B (Refer to Figure 2 or 3). DO NOT cook with any of the surface control knobs in the LITE position (The electronic ignitor will continue to spark if the knob is left in the LITE position). Figure 2 I Center Portion LO "of the Dual Burner adjustment area OFF Hi Single / Figure 4 Dual I Center + Outer Portions Lite position of the Dual Burner adjustment area Figure 3 10 General Care & Cleaning Cleaning Various Parts of Your Cooktop Before cleaning any part of the cooktop, be sure all controls are turned OFF and the cooktop is COOL. REMOVE SPILLOV ERS AND HEAVY SOILING AS SOON AS POSSIBLE. REGULAR CLEANINGS NOW WILL REDUCE THE DIFFICULTY AND EXTENT OF A MAJOR CLEANING LATER. Surfaces Aluminum (Trim Pieces) & Vinyl Painted and Plastic Control Knobs, Body Pieces, and DecorativeTrim Control Panel L', .... lh Stainless Steel, Chrome Decorative Trim Porcelain Enamel Burner Grates, Burner Pans (some models), Burner Skirts (some models), Cooktop Surface Surface Burners How to Clean Use hot, soapy water and a cloth or paper towel. Dry with a clean cloth. For general cleaning, use hot soapy water and a cloth. For more difficult soils and built- up grease, apply a liquid detergent directly onto the soil. Leave on soil for 30 to 60 minutes. Rinse with a damp cloth and dry. DO NOT use abrasive cleaners on any of these materials; they can scratch or dull the finish. Wipe the control panel clean after each use. Before cleaning the control panel, turn all controls to OFF and remove the control knobs. To remove, pull each knob straight off the shaft. Clean using hot, soapy water and a cloth. Be sure to squeeze excess water from the cloth before wiping the panel; especially when wiping around the controls. Excess water in or around the controls may cause damage to the appliance. To replace knobs after cleaning, line up the flat sides of both the knob and the shaft; then push the knob into place. Clean with hot, soapy water and a dishcloth. Rinse with clean water and cloth. Do not use cleaners with high concentrations of chlorides or chlorines. Do not use harsh scrubbing cleaners. Only use kitchen cleaners that are especially made for cleaning stainless steel. Always be sure to rinse the cleaners off from the surface as bluish stains may occur during heating that cannot be removed. Gentle scouring with a soapy scouring pad will remove most spots. Rinse with a 1:1 solution of clear water and ammonia. If necessary, cover difficult spots with an ammonia-soaked paper towel for 30 to 40 minutes. Rinse with clean water and a damp cloth, and then scrub ...
Эта инструкция также подходит к моделям:Варочные панели - 3244 (2.42 mb)
Варочные панели - 3249 (2.42 mb)
Варочные панели - 3248 (2.42 mb)
Варочные панели - 3244 (2.42 mb)